Electronics Forum | Tue Jun 06 13:47:10 EDT 2023 | oxygensmd
In Hungary there are many EKRAs. Bosch, Zollner and many big/small company are using them. I also saw the latest DEK but I think DEK is over-complicated, fast and good printer - but if you have any problem, it cost a lot. MPM also nice machine but I
Electronics Forum | Mon Feb 12 21:38:38 EST 2007 | DEK Answer Guy (PR Dept)
Technical Papers) -ProFlow� upgrades (MPU's). -Paste Low Optimisation -Adjustment of the Print Carriage to ensure Squareness to the Stencil -Replacement of Hinge Pin Assembly -Conversion of ProFlow� to Horizontal Mount -ProFlow� Guides for Operators
Electronics Forum | Mon May 14 09:43:37 EDT 2001 | orbotech
As the face of business changes through revolutionary factors, such as the increasing rate of outsourcing, manufacturers (especially EMS plants) will strive to fine tune their test strategies to ultimately improve and sustain product quality and to r
Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef
Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c
Career Center | chennai, India | Production
i also working in smt operator an 6 mounth.so,i am searching better for my working company.my smt knowledge is operating on printer,pick&place and also reflow and wave soldring.i am operate at full function an the smt machine and i know the all smt c
Electronics Forum | Tue Sep 29 21:39:07 EDT 2020 | kylehunter
Hi, We are currently working on a board that has 3x 50-pin THT at 1.27mm pitch each. This is too small for us to be able to consistently do on our selective solder. We are instead considering pin in paste. The connector we are using can be spec'd at
Electronics Forum | Mon Jan 19 20:01:11 EST 1998 | Steve Gregory
| We use no clean paste and sometimes experience | flux splattering which gives spot on gold fingers. | Need help in analize the cause. thx. Dominic, That is STILL a problem huh? It's a tough one to solve sometimes...especially when you have as
Electronics Forum | Tue Aug 02 15:05:38 EDT 2011 | davef
A couple of points: * Just a nit, 'screens' fell in disuse 10-15 years ago. Old habits die slowly don't they? * Yes, DEK and MPM each hold about 50% of the solder paste printer market and about 4 or 5 others hold the rest. SOLDER PASTE PRINTER EQUI
Electronics Forum | Mon May 18 22:15:20 EDT 1998 | Steve Gregory
Howdy Richard, Welcome to the club! I now dub thee a full fledged member of the "Spotty Gold Finger and Bleeding Ulcer Society"...or SGFBUS for short... (GRIN) I know it's not funny to be in that position, but there's so many different places to pick
Electronics Forum | Tue May 19 10:23:06 EDT 1998 | Mike C
| Howdy Richard, | Welcome to the club! I now dub thee a full fledged member of the "Spotty Gold Finger and Bleeding Ulcer Society"...or SGFBUS for short... (GRIN) | I know it's not funny to be in that position, but there's so many different places t