Electronics Forum | Fri Sep 07 04:19:59 EDT 2018 | spoiltforchoice
You have lost me, its a stencil, you can change the aperture size, you can change the thickness and you can change the walls of the aperture. And all of those things will be in the papers anyone can find with a google. I have no clue what safe air g
Electronics Forum | Thu Sep 06 05:25:38 EDT 2018 | spoiltforchoice
I'm no expert but I think you will find the majority of discussions around BGA & good printing results focus on the PCB design and things like tented vias and pad definition. e.g https://macrofab.com/blog/bga-pad-creation-smd-nsmd/ After that, work
Electronics Forum | Wed Jul 30 11:36:31 EDT 2014 | emeto
About the pads shape - you can do rectangular or oblong. For stencil design oblong is better for small pads(0.2mm) because it will give better release, so having this thought in mind you should probably design oblong shape and then print make paste a
Electronics Forum | Mon Aug 30 16:10:10 EDT 1999 | Dave F
| I have looked through the IPC web page and surfed to frustration. Can somebody give me a lead? | Brian: We don't use an etched board. We use a special stencil, described below and print on bare copper laminate. 3 Solder Wetting Test. Recogniz
Electronics Forum | Fri Jun 04 17:44:20 EDT 2021 | dwl
The hardest part was convincing management of the need for a stencil cleaner in the first place. Cleaning by hand using IPA and a lint free cloth just leads to clogged apertures and print defects. BTW, lint free cloths leave behind a lot of lint.
Electronics Forum | Sat Dec 04 09:23:20 EST 1999 | Christopher Lampron
Kantesh, Does this particular part have a heat sink across the bottom side of the component and does your pad size and stencil aperture match the component? I have just had a very similar problem with a DPAK. What we found was that the recomended pad
Electronics Forum | Thu Mar 08 14:30:45 EST 2007 | ratsalad
If you are in the middle of a run and can't get a replacement stencil there immediately, you can always put a little kapton tape on the bottom of the stencil to mask off a portion of the DPAK pad and reduce the paste deposit. We have had to do this
Electronics Forum | Thu Aug 13 14:10:01 EDT 2015 | markhoch
Hi Sam, I have a feeling that what you're trying to communicate is that your DPAK's are skewing off the pad during reflow. This is caused by a thermal "mismatch" where the solder paste on one side of the DPAK becomes molten before the other, then th
Electronics Forum | Thu May 03 17:33:20 EDT 2018 | dleeper
Solder paste selection can have a huge impact on size and quantity of voids. Talk to a few suppliers and ask for their recommendation on low voiding formulas. Pick a few of your top candidates and then perform a DOE to see who has the best result. S