Industry Directory | Consultant / Service Provider / Manufacturer
EMS company Laser SMT stencils mfg Tape converting , slitting , die cut Laser modules mfg Distribution materials,components ISO 9001:2015 ISO 13485:2016 AQAP 2110:2016 EN 9120:2018
New Equipment | Solder Paste Stencils
Through the increase of mixed technologies, stepped stencils have gained importance to the electronic assembly manufacturer. If the solder paste quantity can no longer be adequately regulated by adjusting Step/Relief Stencil Picture the pad sizes, st
KEPOCH stencils are all laser cut to meet the demands for accuracy and repeatability. Exceptional gasketing and paste release.
Electronics Forum | Wed Apr 26 06:51:11 EDT 2023 | poly
I'm looking to make dedicated tooling for my mpm stencil printer. We only make 3 different boards and they are the same size panel so I'm planning to make one bit of tooling for them. One board is 0.6 mm and sometimes I have problems with it not bein
Electronics Forum | Wed Apr 26 19:10:43 EDT 2023 | cyber_wolf
This machines support table looks similar to AP and UP machines. I believe MPM published the dimensions of the "H" tower that the dedicated plates bolts to. As far as the plate, they are typically (2) pieces with the inside hollowed out to allow for
Used SMT Equipment | Screen Printers
Yamaha YSP Screen printer in excellent condition.Vintage: 2016FeaturesYamaha’s original 3S headAutomatically adjusts squeegee angle (1 degreeunits between 45 to 65 degrees) and speed tooptimize settings for best print results with selectedsolder-past
Industry News | 2001-02-26 11:18:45.0
Innovative Flextac Stencils simplify BGA rework. These self-sticking laser cut, polymer solder paste stencils use a residue-free adhesive similar to Post-it Notes to seal around BGA pads to ensure that solder paste will not bleed under the stencil when the paste is applied. Disposable Flextac Stencils are easy to use and will not leave any residue on the board surface.
Industry News | 2009-11-05 23:37:48.0
BEAVERTON, OR — October 2009 — A-Laser, a division of FCT Assembly and a premier laser cutting service specializing in the ablation of ultra-thin metals and plastics, announces the ability to use its laser technology to cut foam gaskets.
MPM Printer: EdgeLoc™ uses software-controlled pressure for optimal board holding force, automatically adapts to the programmed board thickness, and firmly holds the board without the use of top clamps for optimum accuracy and repeatability.
The MPM Momentum II is a proven, highly productive printer platform with a new set of enhanced technologies for further improvement around machine productivity, yield, ease of use, and flexibility.
