Electronics Forum | Fri Sep 27 15:14:04 EDT 2019 | dilogic
Just one more thought - we had an issue with +12V supply for VME rack. One tantalum cap in the DC/DC converter module for linear encoder interpolator shorted it out, but oddly enough - not always. We ended up hooking scope to all PSU voltages and whe
Electronics Forum | Wed Nov 27 08:54:03 EST 2019 | ttheis
Hi Tushar, Thanks for the reply. I do believe I put it into debug mode but I will be sure to check next time I try logicomm. I am not using any RAMTF or PTF. At the moment I have upgraded the machine from EPC-5 to EPC-5-66 which I found cheap. The
Electronics Forum | Fri Jan 29 13:25:43 EST 2021 | ttheis
Update: I have replaced both dc-dc converters without any improvement. Observing the issue again yesterday I was able to see more of the problem. Logicomm reported a bus error at fcff1043 running "butt" (photo attached.) The DC power ligh
Electronics Forum | Fri Apr 05 18:33:31 EDT 2019 | ttheis
I am also interested in this but to slow one of our machines down- it stops too quickly and shakes the machine more than I would like. We are running GSM1's on OS/2 and uic sw 3.3.
Electronics Forum | Mon Apr 28 12:29:23 EDT 2003 | hruiz
Hi Jax, I�ve took times, and average, we last from 25 to 40 minutes to load a CP6 depending on how big is the load, but quality guys last other 25 min. per equipment to audit, we usually have 2 CP6 and 1 GSM or 1 CP6 and 2 GSM, at any case, we need t
Electronics Forum | Wed Dec 23 12:24:37 EST 2020 | ilavu
1. Palm down the GSM and open the safety cover to check input voltage +12VDC (at KDC2 3PL pins 2 to 3) and output voltage +5VDC (at KDC2 2PL pin 4 to 3) at the DC/DC converter. The DC/DC converter is located inside the control panel assembly ("Nose c
Electronics Forum | Tue Jan 26 05:42:56 EST 2010 | dilogic
Our GSM1 with Flex2 heads started to generate occasional error message: "Axis head 1 theta positive lead error during move absolute command" and then stop. After palm-down it runs again for some time. Everything looks fine, so I have no idea where
Electronics Forum | Mon Jan 15 11:12:08 EST 2007 | jaimebc
I've had experienced this issues here with our GSM's Flex heads. Try this: 1.- Clean your linear scales with alcohol and a lint free cloth. Both the X and Y. This one has fixed the majority of our errors when one of the heads just stops for no apare
Electronics Forum | Fri Apr 28 16:03:31 EDT 2017 | ilavu
I have GSM1 (OS/2) machine and it does not zero. The Y axis comes to all the way front to hard stop. I replaced the limit switch before the hard stop and can not find any way to test the signal from limit switch in diagnostic. I like to replace the c
Electronics Forum | Tue Sep 29 09:39:02 EDT 2015 | rgduval
Hey, David, For service, check out 4TechUSA over in Detroit. It's not Chicago, but, you're closer to Detroit up there than I am down here in Houston :) For your issue....do you have access to the UIC Knowledge Base? The first issue I found in the