Electronics Forum | Thu Jul 09 15:17:48 EDT 2015 | goodting
Thanks for the inquiry. We used MCD (Motion Control Dia) tool to verify if that is caused by VRM board. No respond(I means the related axis was off) was detected. we swapped that board to other machine, the VRM card was good.... X axis was stopped, t
Electronics Forum | Wed Aug 12 12:02:41 EDT 2015 | edwaterfall01
I think the heart beat message comes up if the vision had not initialized. You have changed that already stop I think it is something else. Have you some money a Restore of the Machine Configuration and Mapping and Calibration Data?
Electronics Forum | Tue Sep 29 18:20:56 EDT 2015 | ercdave1
Rob,. thank you very much for the reply. I will follow your recommendations and verify that the stop bar is not damaged or misaligned. I will also thank you for the info for the service . I will keep you posted. Thank you again. David
Electronics Forum | Thu Mar 20 15:57:57 EDT 2014 | edwaterfall01
The numeric display number should be higher but only when all 7 spindles are moved down slightly from the full up position. The 7 spindles retract up to the Stop Bar. Each spindle assembly has a tapered hole thru it. This hole is in the block with t
Electronics Forum | Mon Sep 20 20:43:19 EDT 2021 | ttheis
One of our GSM machines started having an issue with "spitting" parts onto the board / blowing them around. I determined the problem be that spindle #2 on our flex head is not touching the parts all the way down to the board. It is stopping just abov
Electronics Forum | Wed Mar 15 10:07:17 EST 2006 | geb
*** New related Question*** Thank you for your suggestions. Unfortunately it is still not working though. I have noticed at the top of the "General Purpose I/O Chassis" that a red LED next to PCB location 0 is permanently on. But this is not on on o
Electronics Forum | Sun Jul 08 06:38:41 EDT 2007 | dilogic
We have an old GSM1 (I-block, USOS V1.4.14, two 4-spindle heads, changers between rails). When I configure machine so there are no nozzles on heads and changers are filled with required nozzles, except for one empty hole, machine won't pick up nozzle
Electronics Forum | Thu Sep 17 18:22:06 EDT 2020 | astarotf
Hello We have a GSM machine with two heads from the universal company, currently the machine fails to zero and in production mode, when the heads increase the displacement speed in the Y axis, they stop immediately. And the error illustrated in the i
Electronics Forum | Mon Apr 01 20:25:48 EST 2002 | davef
Stop!!! Whoa!!! Time-aut You have equipment like "Siemens 80S & 80F, Sanyo TCM 3000 and GSM" and you're not going to convince people to clean the ever lovin' bejuice out of your stencils? You're thinking handy-wipes are going to get it done? Wha
Electronics Forum | Tue Jun 26 08:47:09 EDT 2007 | geb
Hi we have a Universal GSM 1 flex head machine. It keeps on bringing up an "Axis Head 1 Z velocity over speed error during move absolute command". Pushing the e-stop button and then start again will allow it to continue making the panel. It happens r
