Electronics Forum | Fri Aug 06 06:38:52 EDT 2010 | mun4o
Turn the panel 90 degrees.
Electronics Forum | Wed May 04 11:49:24 EDT 2005 | thomasleetch
Does any one have a picture of a unversal stencil adapter for a SPM printer? We have stencils for Dek machines that are 25" by 23"wide that we need to turn 90 degrees to be able to center the pattern for the spm printer.Or do you have one for sale? T
Electronics Forum | Wed May 04 11:51:45 EDT 2005 | thomasleetch
Does any one have a picture of a unversal stencil adapter for a SPM printer? We have stencils for Dek machines that are 25" by 23"wide that we need to turn 90 degrees to be able to center the pattern for the spm printer.Or do you have one for sale? T
Electronics Forum | Fri Jan 27 11:03:53 EST 2006 | bvdb
We are a New Zealand company that purchased a used Fuji IP-1 locally. There is no Fuji support here but we've managed to get the IP-1 up and running with just the use of the manuals. There are many things that the manuals do not explain and I would
Electronics Forum | Tue Oct 16 01:29:11 EDT 2012 | dman97
I have a very odd problem with my Fuji IP3 and was wondering if anyone can help. Any part that gets picked from the MTU will fail vision recognition. After turning on the vision trace data, I can see that the IP3 is looking for the part to be rotat
Electronics Forum | Thu Dec 22 16:12:51 EST 2005 | chunks
Off the Cuff Answer: Wow, nice big ugly connector! Thought we were the only ones using these things designed during the Korean war. Actually it really depends on the customers print. If they want conformal coating, they should know exactly where
Electronics Forum | Mon Dec 02 10:33:46 EST 2013 | sarivong0914
Hello all, We have a Samsung CP45FV Neo, and I'm having problems with the operating software. I have a PCB with 2 different rev's. Rev. A boards was programmed to run Vertical. Then Rev.B boards are horizontal but was programmed to run vertical.
Electronics Forum | Mon Apr 18 06:17:58 EDT 2016 | smtsparescn
If there are too many components on the board and many components are standing near the board edge,to use a depaneling machine is a simple way,but a machine is needed, another possible way is to design and make a simple fixture,it holds the board fi
Electronics Forum | Thu Aug 20 08:23:23 EDT 2009 | ratsalad
One diagnostic tool that I have found useful in the past is the "hot plate test". Place suspect components and/or PCB's on a hot plate and turn it on High. Then observe. Granted the conditions on the hot plate are not the same as in a reflow oven,
Electronics Forum | Mon Jul 13 06:30:59 EDT 2009 | hcarrasco
1.- Check your vacuum a.- Check filters b.- Check air flow (the vacuum is generated by a Ventury using air flow, not air pressure) c.- Vaccum vias (Possible linth inside the vacuum lines) 2.- Check the nozzle condition (Probably broken o
