Electronics Forum | Thu Sep 05 07:14:16 EDT 2019 | smrsteve
Hello Bobpan, Thanks for the suggestions. Sorry I didn't reply yesterday as I'd gone home - I'm in the UK, so I'm guessing there's a time difference. Okay, I found the control to turn off the vacuum verify - it's SHIFT - SWITCH/VERIFY. Makes no di
Electronics Forum | Tue May 02 05:35:07 EDT 2000 | Donnie
There are a number of different things to ask youreself here. What type of flux are you using. 330, 351, 310 etc. Do you have a hot air knife? As for the residue, that's gonna show on almost any wave soldered pcb. We have fought the issue for a long
Electronics Forum | Wed Mar 31 21:57:21 EST 2004 | pdeuel
Minor problem with rejected parts on a GSM C4 single flex head. UIC support was helpfull but I thought some of you may have encountered this problem and know what's the matter. We are rejecting 1 out of 3 SOT-63 parts. The problem is occuring to part
Electronics Forum | Sun Sep 19 10:54:24 EDT 2004 | rohman23
This (along w/ everything else we do) is not high volume. Actually, we're dropping a batch of 7 the first of the week, and that's fairly sizeable for us. I talked with my stencil design folks and sent them a scrap board and all my gerber info. I t
Electronics Forum | Wed May 29 07:41:33 EDT 2024 | tommy_magyar
We use the same component on many different products, never faced a similar issue. However, things I would check are: - stencil thickness (ideally 125um) - additional Z move on the parts around the relay (as suggested by kumarb) - check the packages
Electronics Forum | Fri Jan 15 11:26:24 EST 1999 | Chrys
Hello, We are qualifying new sources of PWB vendors. We've got the first lot of "produciton" boards in and we want to put them through the paces before turing the vendors on. So far, the tests I can think of performing, and that we have the capabi
Electronics Forum | Tue Aug 28 08:28:30 EDT 2012 | rgduval
We agree with all of the previous comments, and would add the following: Warpage is generally caused by excess moisture in the raw boards. Have you tried baking the boards prior to assembly? We had this issue on a simple 4-layer board, and found t
Electronics Forum | Wed Oct 28 02:03:18 EST 1998 | Erhard Hofmann
| | | We currently using the Panasert SMT machine where PCB flow | | | direction were from right to left, & we are planning to move | | | in the FUJI -CP3 & CP4-2 in line where standard PCB | | | flow direction were left to right. | | | Any comment o
Electronics Forum | Tue Jul 03 08:14:49 EDT 2001 | Stefan Witte
If you hold your board sideways in a 90 degree angle you apply a force of 1 g to your components. 1 g translates into 32 ft / sec. square. This is not too much acceleration for fearless roller coaster drivers but Melf�s and Tantalums can fall off at
Electronics Forum | Fri Jan 15 11:33:46 EST 1999 | Bob Willis
| Hello, | | We are qualifying new sources of PWB vendors. We've got the first lot of "produciton" boards in and we want to put them through the paces before turing the vendors on. | | So far, the tests I can think of performing, and that we have
