Electronics Forum | Tue Jun 23 13:50:05 EDT 2020 | dltechltd
505.05 SP2 Hotfix3 After this, we were able to work with the machine until 1 week and the machine broke again. A small zener diode exploded on a Servo card, and we replaced it. Next reboot, the MC system halted, because an SRBS error. We have aske
Electronics Forum | Wed Jun 11 11:12:10 EDT 2003 | JB
We rarely use the tack-time on our machines, even if we run products that are populated with large components. ( ICS, Tant caps etc.) There is a default tacktime for each component on the component library, is called Speed Data. For the components
Electronics Forum | Wed Sep 08 08:25:26 EDT 1999 | Brad Kendall
Listed below are the issues Viking has been experiencing since the | installation of the Proflow Head: | 1. After installing new 350mm Wiper foil with metal | strip glued on it, It worked for about a week and suddenly meta
Electronics Forum | Tue Oct 26 00:03:09 EDT 2010 | jmelson
Hmm, that's a fairly old machine, even older than mine! (I have a CSM84 PA130640). Anyway, it is best to program the machine from CAD system data, I wrote a little program in C to read in the component type and XYR position, and produce the file in
Electronics Forum | Thu Sep 12 08:22:30 EDT 2002 | caldon
YOU think I could let this posting go by with out a reply??? PLEEEEASE. Genny- No matter what direction you go do your home work. This will require a lot of home work on you and your staff. If you go the contract manufacturing route GREAT!!! But hav
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Sat Aug 07 11:33:55 EDT 1999 | JohnW
| | What oven temperature should be used to reflow solder (Sn63Pb37) on a PC board (0.075" to 0.100" thickness) in 5 to 10 minutes? | | Profiling - tedious but important. As said, start with the paste manufacturers recomendation which is usually pu
Electronics Forum | Fri Mar 06 10:30:46 EST 1998 | Ron Costa
| | | Hello everyone! | | | Does any know anything about bare board size variations? | | | Is there a spec. or tolerance? | | | I'm running small lots of boards and during the screen printing process | | | I find that I cannot paste each board perfec
Electronics Forum | Sun Aug 08 20:59:55 EDT 1999 | Dreamsniper
| | | What oven temperature should be used to reflow solder (Sn63Pb37) on a PC board (0.075" to 0.100" thickness) in 5 to 10 minutes? | | | | Profiling - tedious but important. As said, start with the paste manufacturers recomendation which is usua