Cleanly and easily separate tab routed PCBs without dust. Singulating tab routed printed circuit cards in low to medium volume production quantities is safe and easy with the N100 Nibbler from FKN Systek. Blades are available in standard thicknesses
Industry News | 2022-02-17 12:52:30.0
Cleanly and easily separate a row of up to 10 tabs without dust. Singulating tab routed printed circuit cards in low to medium volume production quantities is safe and easy with the N115 Nibbler from FKN Systek. Two sharp support blades on either side of the tab help cleanly slice the PCBs from the tabs.
Singulate Straight Tab Routed Panels Store cut tabs inside tool for discarding at operator convenience Available with 3 blade types and choice of support dies Clean cut - requires no rework for deburring PCB edges Easy blade change in under 5 m
Used SMT Equipment | Soldering - Selective
Hot Bar Soldering Flex Circuit to PCB Ribbon Cable to PCB Coaxial Cables Fine Pitch SM Devices Edge Connectors to PCB Thermocompression Bonding Tab to PCB, HSC to LCD or tab More information pjbril@smtunion.com m.madera@smtunion.com W
Safely Singulate Tab Routed Panels - With Dust Extraction Finish routing a tab routed PCB for singulation is a relatively slow process . However, in some cases, where the board contours and sensitive or overhanging components may require, this may b
Industry News | 2022-09-21 08:26:26.0
Cut up to 10 Tabs in one Stroke
Industry News | 2016-11-17 15:22:21.0
The N200 punch cleanly separates round and odd shaped panels without dust. Available for under $4,000 from FKN Systek, The N200 is a low cost top down air operated punch for singulating tab routed PCB Panels one tab at a time. An upper and lower matching knife blade is used to pinch the tabs apart.
Events Calendar | Mon Sep 23 00:00:00 EDT 2019 - Wed Sep 25 00:00:00 EDT 2019 | Millis, Massachusetts USA
SMTAI Rosemont
Industry News | 2017-01-25 16:39:34.0
Singulating tab routed printed circuit cards in low to medium volume production quantities is safe and easy with the N100 Nibbler from FKN Systek. Blades are available in standard thicknesses of .120”, .093” and .062”. Custom sizes to match the width of the routed section can be ground. Tabs are cut cleanly on each side so that no further clean up is required to remove excess material, as is often the case when using hand tools or when breaking the panels manually. In addition, since only one tab is cut at a time, minimal stress is imparted to the board during the process as the panel is not pressed between two points during the cut.
.gif)
winsouce.jpg)