Electronics Forum | Tue Oct 31 13:15:13 EST 2006 | realchunks
SWAG is prolly right. You can verify the tactile sensor by watching the machine carefully. When finding the stencil height, make sure the board goes all the way up and touches the stencil to trigger the tactile. If it doesn't, then something is wr
Electronics Forum | Tue Aug 04 10:43:48 EDT 2009 | kpm135
Thanks for the suggestions! It ended up being that a wire on the amplifier card in the lower drawer came loose and was making intermittent contact. Tightened all the wires down and the problem has gone away. Now we have a new problem. We had to repla
Electronics Forum | Mon Mar 15 09:55:53 EST 1999 | Justin Medernach
| After rmoving a BGA (plastic)to correct unexplained shorts | I installed another BGA using flux only. | Checking on an X Ray machine and found two shorts. | | can anyone give a good explenation ? | | Thanks | | Ron | Ron, It could be a number o
Electronics Forum | Mon Mar 15 16:07:32 EST 1999 | Earl Moon
| | After rmoving a BGA (plastic)to correct unexplained shorts | | I installed another BGA using flux only. | | Checking on an X Ray machine and found two shorts. | | | | can anyone give a good explenation ? | | | | Thanks | | | | Ron | | | Ron,
Electronics Forum | Fri Mar 19 08:51:57 EST 1999 | Justin Medernach
| | | After rmoving a BGA (plastic)to correct unexplained shorts | | | I installed another BGA using flux only. | | | Checking on an X Ray machine and found two shorts. | | | | | | can anyone give a good explenation ? | | | | | | Thanks | | | | |
