Electronics Forum | Wed Oct 25 13:02:54 EDT 2006 | billyd
Thanks all, for the help. Mydata pretty much parroted what was said here. My biggest issue is too many clowns in the circus tent. Thanks again guys.
Electronics Forum | Wed Feb 20 16:52:11 EST 2008 | pms
Yea, I'm still here.....sigh. Got bridging problems. These assemblies are SMT topside, then go thru wave for thru-hole components on topside. These assemblies have many, many, many vias VERY close together. We have a problem with solder from the wa
Electronics Forum | Thu Aug 20 04:37:03 EDT 2009 | sergey2007
Hi, I also paid attention on the solder balls.. I thought it was because of the pop-corning, but the customer told me the component was not damaged.. Regarding the bunch of tented vias, I need to ask the customer about that. Probably, they have unpo
Electronics Forum | Wed Jan 27 20:11:36 EST 2010 | plerma
What material is used to cap a via? Is it the > standard LPI Process/Material? we tent vias all the time, mostly to assist with assembly and the majority of the time outgassing is not a problem. What is the purpose in your case?
Electronics Forum | Tue Mar 03 02:39:56 EST 2015 | sarason
I would presume you reflow the top of the board first. Use tented vias. As you have worked out, vias have surface tension, which sucks the solder up the hole during reflow of the bottom of the board. Good luck! regards sarason
Electronics Forum | Tue Mar 03 03:11:57 EST 2015 | vb7007
Hi I also forgot to mention, top side is reflowed first at SMT. Tenting vias is good option. we are looking into it. Can you please also suggest any solution to avoid solder balls at bottom side in other places than vias. Thanks
Electronics Forum | Fri Dec 01 15:22:46 EST 2017 | kojotssss
Recommended land and solder pattern says: VIA wall plating, via holes should be tented with solder mask on the backside and filled with solder. Solutions at this moment ? Thanks for all :)
Electronics Forum | Sun Nov 24 20:43:15 EST 2019 | sssamw
If you want to check if solder mask on tented via, better to do cross section to have a clear view. Sometime supplier will not tell you the truth once you ask question for potential quality issue.
Electronics Forum | Mon Feb 26 12:26:43 EST 2001 | CAM
I'm working a problem and looking for your input. Here the deal: Two sided mix technology board. Test is using unmasked via points on bottom for test points. Our fab drawing states tent via points on top side. First set of board came in with no tenti
Electronics Forum | Wed Jul 07 13:41:42 EDT 1999 | Dave F
snip | | If you go for plugging be sure you have a protrusion spec that you can live with. This often results in little bumps of epoxy that can interfere with component placement. For us, tenting .015 vias usually gets us about 80% coverage from
.gif)
