Electronics Forum | Thu Apr 18 14:09:57 EDT 2013 | bobpan
Just because a feeder has 8 pins on the front does NOT mean it is IQ. The IQ feeders started at a certain level of feeder part number.....which i do not remember being that many people dont use the IQ system. Good Luck
Electronics Forum | Fri Apr 19 05:26:22 EDT 2013 | bobpan
There should be a sticker on the feeder that says 10-??????. This is the feeder part number. I think the IQ feeder manual tells you at what point the feeders will communicate with the IQ software.
Electronics Forum | Thu Apr 18 17:42:26 EDT 2013 | navworx
Just because a feeder has 8 pins on the front > does NOT mean it is IQ. The IQ feeders started at > a certain level of feeder part number.....which i > do not remember being that many people dont use > the IQ system. > > Good Luck It has PLD v
Electronics Forum | Sat Jan 13 19:34:16 EST 2007 | geb
(Its a flex head) I have made a trial program to determine at what point it stops. This is how it goes: I load the program, push the start button it will zero and pick components with head 1. As soon as it finishes placing head 1 parts it halts wher
Electronics Forum | Thu Jul 03 09:27:10 EDT 2014 | torch
Hey guys wonder if anyone can help me, having an issue with our Quad QSP2, at the moment it is displaying Tep2 - Send Status command failed Tep1 - Send Status command failed and there is no response from the gantries, the interlocks appear to be wo
Electronics Forum | Thu Aug 08 11:04:48 EDT 2019 | btfonseca
Hi everyone, I was recently trying to troubleshoot a bad floppy driver on our QSV-1, which actually worked, I was able to read floppy drives but for some reason it all went downhill when one of the green LED's turned off and another red LED turned on
Electronics Forum | Fri Jul 26 09:37:45 EDT 2019 | babe7362000
I got it BOB, just the TEP card needed seated more. Thanks
Electronics Forum | Tue Jul 29 17:59:53 EDT 2014 | guts1872
I have had to flush the ram when replacing a TEP controller. These are kind of scetchy instructions from my notes, never could get PPM to send me any procedures. Hope this helps. Plug keyboard and monitor into RT computer and navigate to 2kla/RT/TEP
Electronics Forum | Sun Jan 20 17:47:41 EST 2013 | ngineer
Bobpan, It's been a while, and I haven't really had a need for this (simple boards, with larger components), but now I'm back to a board that needs this. I only have options for HOLD, PASS or VISION under transport in the Sequence Programming.
Electronics Forum | Fri Feb 24 09:24:08 EST 2012 | bobpan
1. You should be running the machine from the computer and central contoller. (not the handheld or run button on machine) 2. What is the tep commands in your sequence steps....I think you need to have tep vision as the first step and tep vpass at the
