Electronics Forum | Tue Feb 14 13:16:49 EST 2006 | Carol Stirling
CRITICAL DILEMA! Has anyone run into the problem described below and if so, what was the fix (besides not dealing with this Supplier)? Also, we do not have component manufacturing process experience. We are purchasing a surge resistor that function
Electronics Forum | Tue Feb 14 22:48:06 EST 2006 | Cal Kolokoy
That is a tough situation and a tough answer for us SMT forum participants. After all, most of us are in the business of placing and soldering components to circuit boards, and you know the saying; you can't make solder joints with an unsolderable su
Electronics Forum | Fri Jan 05 09:23:10 EST 2001 | Brian Toleno
While there may not be any specific requirement to cleaning prior to coating, cleaning an assembly prior to coating will only serve to increase the reliability and integrity of the coating. Some residues from low-solids fluxes can interact with conf
Electronics Forum | Thu Apr 20 17:16:02 EDT 2006 | GS
Silver tarnish on lead could compromise the soldering, mainly in case of No Clean process. Make sure components are correctly packaged and stored. Check the vintage ( Manufacturing Data Code) and in order to avoid them to get old on shelf make sure F
Electronics Forum | Tue Feb 03 16:42:50 EST 2009 | cuperpeter
Hello All, > > I have a problem with nonwetting Au > finish after second cycle of reflow soldering > doublesided boards. Solder nonwetted pcb pads (is > wicked to component terminations) Either these > pads or some of non component pads became
Electronics Forum | Sun Nov 08 15:27:25 EST 2015 | davef
Thinner: Flux thinner, NOT paint thinner We kept a spare stone in thinner in inventory. We cut PVC pipe to size, cap in one end, screw thread on the other, stone inside, filled with flux thinner and covered with a screw cap. I don't remember who we
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Sun Apr 13 19:50:20 EDT 2003 | yukim
Hi, We are placing (+) & (-) terminals in SMT. We have just changed the plating of them: from Nickel to Tin (Sn). During the trial, we used the same reflow profile as before changing, and the solder seems different: a bit cold, with some solder paste
Electronics Forum | Fri Aug 20 12:54:11 EDT 1999 | Carol Zhang
| | I am being asked, by my vendor and Purchasing people about converting from Tin/lead pads on P.C.B's to Electroless Tin Plating. | | Can any one tell me what I have to change in my SMT | | process (paste, reflow, etc) If any? | | I ran one
Electronics Forum | Fri Aug 20 12:18:11 EDT 1999 | Earl Moon
| I am being asked, by my vendor and Purchasing people about converting from Tin/lead pads on P.C.B's to Electroless Tin Plating. | Can any one tell me what I have to change in my SMT | process (paste, reflow, etc) If any? | I ran one P.C.Boar
.gif)
