New Equipment | Selective Soldering
Enhanced, entry-level, single point selective soldering system With all the proven features of the Jade MKII, the Jade MKIV sets even higher standards of performance. Designed to meet the needs of the small/medium batch manufacturer who requires hi
New Equipment | Selective Soldering
Designed to meet the needs of lean manufacturing, the Jade Handex offers high-speed flexible throughput at minimal cost. The Jade Handex is equipped with a revolutionary twin PCB rotary table transport system to allow simultaneous load/unload during
Industry News | 2024-03-11 15:00:03.0
Connect with our experts and see plasma and dispensing equipment for microelectronics manufacturing in booth 3645
Technical Library | 2007-01-31 15:17:04.0
The goal of this project is to evaluate the reliability of lead-free BGA solder joints with a variety of different pad sizes using several different BGA rework methods. These methods included BGAs reworked with both flux only and solder paste attachment techniques and with or without the use of the BEST stay in place StencilQuick™. The daisy chained test boards were placed into a thermal test chamber and cycled between -25ºC to 125ºC over a 30 minute cycle with a 30 minute dwell on each end of the cycle. Each BGA on the board was wired and the continuity assessed during the 1000 cycles the test samples were in the chamber.
Industry Directory | Consultant / Service Provider
Design and manufacture of thermal systems for rapid temperature verification and testing, and process cooling. Includes small-footprint thermal chambers and plates, mobile temperature forcing systems, and process chillers.
New Equipment | Test Equipment
A redesigned website with temperature test and conditioning content for design and manufacturing engineers has been introduced by inTEST Thermal Solutions. The new site delivers information about temperature controlled environments including thermal
Industry News | 2018-10-18 08:42:00.0
Reflow oven zone temperature set up and thermal profile
Technical Library | 2019-11-12 02:09:22.0
Thermal shock test chamber can be used for testing the chemical change or physical damage on composite materials caused by the thermal expansion and contraction of the sample in the shortest time,which is subjected to extremely and continuous high and low temperature environment.so how to check the temperature recovery time of this chamber? Normally we take following steps to inspect the temepratuire recovering time: 1.Install the temperature sensor at the specified position, and adjust the temperature controller of hot zone and cold zone to the required nominal temperature respectively. 2.The temperature increases and reduces respectively,30min after temperature in two zones reach stable status,record temperature value of the measuring point,pls set the temperature value of two zones to be required nominal temperature. 3.The temperature shock test chamber automatically places the inspected load into theh ot zone,select the corresponding retention time according to regulated standard. 4.Set the transfer time,then the inspection load is transferred from hot zone to cold zone, and the temperature of the measuring point is observed and recorded, and then the reverse conversion of the load from cold zone to hot zone is carried out according to the same method, and the temperature of the measuring point is observed and recorded. www.climatechambers.com
Industry News | 2014-10-01 14:09:23.0
San Diego — October 2014 — KIC today announced that it was awarded a 2014 Global Technology Award in the category of Soldering Equipment – Reflow for its K2 new generation profile setter.
Used SMT Equipment | General Purpose Test & Measurement
Hi, We are Looking for a refurbish Thermal Shock model TSE -12- A. Kindly quote best price CIF Malaysia include training and installation. Thanks Aruna.
.png)
