Electronics Forum | Fri Apr 11 06:22:04 EDT 2008 | andrzej
Hi Andrzej, > > We are using for BGA (0.8 pitch) > square apertures size 0.4 mm (rounded corners r = > t) and stencil thickness t=5 mils. So area > ration-_ w/4t=0.8 > > Regards Jan Hello Jan, I understand that you have the same pad dimensio
Electronics Forum | Fri Apr 11 01:52:26 EDT 2008 | andrzej
0,66 Is it ok ? Is it overprinted r - radius of stencil aperture - 9mils ~ 230um t - stencil thickness - 150um Other data : diameter of soldermas - 26mils Diameter of pad - 18mils Diameter of stencil apertre - 18mils Pitch - 0,8mm ~ 31mils What s
Electronics Forum | Wed Aug 29 03:16:20 EDT 2018 | cannizzaro
It is recommended that the thickness of the stencil of 0.1mm, the steel mesh should be partially nano-coated. It is best not to dry easily, and the particles are not easy to be too large. I have tried ALLPCB for this kind of BGA in the past and they
Electronics Forum | Wed Sep 25 11:11:14 EDT 2002 | xrayhipp
Try .005 or even .004 thick laser cut electopolish stencil and reduce grain size of paste. Go with 400 or 25 in the case of AIM. We had a similar prob.
Electronics Forum | Wed Feb 22 10:00:58 EST 2006 | dougs
We've just set up a couple of products with 0.5mm pitch uBGA devices on them, i went for 5thou thick, laser cut nickel (to aid paste release) square pads same size as the diameter of the uBGA pads. Or you could go to a 4 thou nickel stencil, better
Electronics Forum | Tue Feb 04 22:28:16 EST 2003 | davef
You could reduce the paste by about 70%. Solder balling and tombstoning will be the issues to fight. The drivers to these don't change with the component size. Use the fine SMTnet Archives for background. Aperture Size and Thickness of Solder Pas
Electronics Forum | Thu Feb 24 10:52:41 EST 2000 | JAX
Robert, Here's my recommendation's: Solder paste opening on screen should equal the solder mask opening on board. Stencil thickness at .008" but this should not be your main concern as stencil thickness should be determined by the fine pitch that ar
Electronics Forum | Thu Feb 24 10:52:41 EST 2000 | JAX
Robert, Here's my recommendation's: Solder paste opening on screen should equal the solder mask opening on board. Stencil thickness at .008" but this should not be your main concern as stencil thickness should be determined by the fine pitch that ar
Electronics Forum | Thu Feb 24 06:09:26 EST 2000 | Robert Hutton-Squire
Hi, - any suggestions welcome... I have a 484 pin ALTERA fineline BGA - ball pitch 1mm (40) - ball size 0.48mm (18.9) What would you recommend for... 1. Surface pad size for the balls of this BGA device? 2. Stencil thickness/type and hole a
