Electronics Forum | Sat Mar 29 08:50:30 EST 2003 | davef
Barry Echoing an earlier poster, replace your stone. Use the suppliers' recommended thinner. Do NOT use isopropanol [IPA]. IPA contains water. Water is the bane of low residue soldering. It will get you in trouble fast. From IPC, get your hand
Electronics Forum | Wed Sep 17 10:49:48 EDT 2003 | davef
We agree. Colin Lea showed that HASL less than 2 microns [80 uin] thick has limited shelf life and that shelf life gets worse as the HASL gets thinner. Unless you do not need shelf life, consider sticking with 100 to 500 uin. There is nothing wrong
Electronics Forum | Mon Mar 03 10:38:28 EST 2003 | davef
Electroplated nickel and electroplated gold is the more �traditional� finish for aluminum wire bonding. That surface was an extension of gold thermosonic wire bonding that requires a thick [50 thou min] gold surface. For years fabricators recommend
Electronics Forum | Tue Apr 01 13:01:27 EST 2003 | cnotebaert
I have NOT done 0402's yet but also have no trouble with 0603's. Did you try any thinner stencils? I don�t know this for a fact just speculating, I would think the 0402's have a smaller brd to chip gap and that you might be able to get away with a 4
Electronics Forum | Fri Sep 19 11:39:38 EDT 2003 | joeherz
We have recently started building a new assembly that is exhibiting some strange behavior. We are seeing what look like blow holes in wave soldered joints. When the joints are touched up, the solder in the barrel will actually bubble up from the ho
Electronics Forum | Wed Dec 17 03:26:17 EST 2003 | Kev
Hi Lads, Thanks for all of the replies. To answer a few of your questions..... My wave is a Hollis PT500N. It has 3 zones of pre-heater rod elements. Each individual element (601195-01) is 500 watts. There are 16 elements per zone so 8 Kw per zone.
Electronics Forum | Fri Oct 03 07:49:18 EDT 2003 | mk
Mask Musings. Soldermask (SM) and its functions have changed and evolved over the years. As an ex-solder mask applicator, I can remember screening Colonial High Gloss Epoxy soldermask on boards back in the early 80's, ending up with a thickness that
Career Center | Gurgaon, India | Engineering,Management,Production,Purchasing,Quality Control
1. Quality Function Management • Ensure timely inspection at incoming, in-process & outgoing stage. • Non-conformance review & reporting. • Decision making - Right disposal of Non-conforming material. • Determination of Vendor Quality rating (VQR
.png)
