Electronics Forum | Fri Aug 13 10:00:45 EDT 1999 | Boca
| | Ladies and Gentlemen, | | | | As a newly appointed DFM/CE "guru" here, one of my responsibilities has become repair (of course). As I have some knowledge of BGA repair/rework using semi-automated equipment, it naturally follows I would hav treme
Electronics Forum | Fri Apr 23 04:02:22 EDT 1999 | Scott Davies
I need to know if there are any special component pad designs that need to be considered when evaluating paste-in-hole? We have a few through hole connectors that are good candidates to place pre reflow. Does anyone have sugguestions. Thanks Chri
Electronics Forum | Wed Apr 06 12:36:53 EDT 2005 | smt_rookie
I've tried a different lot of the same double header connector (yes its double level right angled header conector) twice but nothing has improved. I've also suspected that top row of the connector has greater heat sinking capacity (which should hold
Electronics Forum | Wed Dec 05 03:33:22 EST 2007 | longlee
We have done Paste-In-Hole process for 4 years.I think this prcess is suitable for 28-pins connector. Of course, you must assure the connecotr can endure high temperature firstly.Secondly, you need calculate the volume of solder paste, you can refere
Electronics Forum | Tue Aug 17 10:48:16 EDT 1999 | Earl Moon
| | | | | | Ladies and Gentlemen, | | | | | | | | | | | | As a newly appointed DFM/CE "guru" here, one of my responsibilities has become repair (of course). As I have some knowledge of BGA repair/rework using semi-automated equipment, it naturally f
Electronics Forum | Wed Aug 28 18:08:07 EDT 2002 | MikeF
This looks like it may be a good application for an Air-Vac or Wenesco type solder station. It is a solder pot that has a small motor to pump solder up through a chimney. You can put different nozzles on the top of the chimney, so you only apply sold
Electronics Forum | Tue Aug 17 10:32:19 EDT 1999 | Boca
| | | | Ladies and Gentlemen, | | | | | | | | As a newly appointed DFM/CE "guru" here, one of my responsibilities has become repair (of course). As I have some knowledge of BGA repair/rework using semi-automated equipment, it naturally follows I wou
Electronics Forum | Tue Aug 17 10:35:52 EDT 1999 | Boca
| | | | | Ladies and Gentlemen, | | | | | | | | | | As a newly appointed DFM/CE "guru" here, one of my responsibilities has become repair (of course). As I have some knowledge of BGA repair/rework using semi-automated equipment, it naturally follows
Electronics Forum | Tue Aug 17 12:34:33 EDT 1999 | John Dwinell
| | | | | | Ladies and Gentlemen, | | | | | | | | | | | | As a newly appointed DFM/CE "guru" here, one of my responsibilities has become repair (of course). As I have some knowledge of BGA repair/rework using semi-automated equipment, it naturally f
Electronics Forum | Wed Jun 05 13:01:26 EDT 2002 | Hussman69
Sure do. Spent a couple months with that group last winter trying to get the Soft Beam to solder a small connector board. It really depends on what you are trying to solder. The Soft Beam couldn't handle my job because our board was too small. No
