Used SMT Equipment | Turnkey Lines
Functional Pre-Owned Complete SMT Assembly Line - Still Operational (Subject to prior sell, I am listing this on other venues) Up for sale is a full turnkey SMT line and all of it's accessories, of which there are a lot, fe
Electronics Forum | Thu Jun 13 09:39:43 EDT 2019 | don_julio
Problem is I don't have a mesh belt (lesson learned). Our conveyor is pins. If I laid some scrap pcb's spanning the conveyor pins on the long dimension of the board, I'm confident it would sag. We get a bit of sag today in our 1.6mm thick boards whi
Electronics Forum | Tue Jun 12 10:13:10 EDT 2001 | techment
Thank you, Mr Dave. Specifically, there are tiny balls spreading on the boards ( on top of solder resists, and not encapsulated). They are not near to any land/pad or connector. I do not think they post any electrical problem. They are quite far away
Electronics Forum | Sat Jul 29 09:10:16 EDT 2006 | davef
Ball Grid Array (BGA). A surface mount technology leadless package with the connectors to the board placed in an array on the bottom of the package. They are attached to the board with tiny balls of solder placed on each contact. Pin Grid Array (P
Electronics Forum | Wed Aug 12 00:16:43 EDT 1998 | Ron Costa
Hello everyone, I am currently running a gold plated SMT board and am experiencing tiny solder balls between the pads and the masking between the 20 mil pitch devices. I'm looking at these boards with a 60x microscope. IPC-610 say's any visible solde
Electronics Forum | Mon Nov 19 18:58:28 EST 2007 | jmelson
On big chips, we use a tape printing device, I think it is a Brother PT1750. We have a small device, though, that is in an SO8 package, and the only thing we've come up with is to scratch a product letter code and the program date with a stylus. Th
Electronics Forum | Tue Apr 03 15:48:35 EDT 2007 | Cmiller
If the Bliss carts would help you can cut some money out by buying aluminum bakers carts at your local restaurant supply house for less than $100/each and then buy ESD trays from another local source (Bliss is rather pricy). You will have to hang a c
Electronics Forum | Mon Feb 22 10:01:01 EST 2010 | jtsyeung
Since the inductor is electro-magnetic, that means the device is composite of coil and ferrite metal. The inductor inside the reflow oven meets with blower motors which close to the inductor and generate magnetic field. With such conditions, Lawren
Electronics Forum | Wed Jun 23 13:34:29 EDT 2004 | df_indy
I am four weeks into my new job, there always seems to be some issues here with PCB every week. Today while I was checking some assemblies with micro-scope, I found a lot of tiny bubbles/blisters on the board. They are just little dots if you look
Electronics Forum | Wed Jul 30 00:47:10 EDT 2014 | matusov
Hello gurus, I am a hardware designer with a small company. We are about to send a new PCB for fabrication. This board uses dozens of tiny QFN, DFN, and similar packages. As a final check I have been going through the datasheets of all these parts t