Electronics Forum | Thu Jun 17 10:25:43 EDT 1999 | Brian Wycoff
| | We are a medium sized PCB assy. house manufacturing about 2000 motherboards a day. There is a major problem we are facing at the wave soldering stage, i.e. warpage of the PCB. As soon as the PCB touches the wave it warps severely from the centr
Electronics Forum | Mon Jun 14 09:23:57 EDT 1999 | C.K.
| We are a medium sized PCB assy. house manufacturing about 2000 motherboards a day. There is a major problem we are facing at the wave soldering stage, i.e. warpage of the PCB. As soon as the PCB touches the wave it warps severely from the centre
Electronics Forum | Tue Oct 07 08:44:49 EDT 2014 | emeto
Hi, 1. I will run the board on the mesh if single sided. 2. For double sided board, I will try stiffeners. 3. If stiffeners don't work, then you have to create a handling fixture(holds the board and has enough openings to let the air flow to the PC
Electronics Forum | Tue Feb 23 14:21:17 EST 1999 | Mike McMonagle
| A rash of new products here at my company have designs with multi-pin connectors 90 out-of-phase (orientation)wiht respect to wave direction, which has lead to massive bridging (shorts) problems.... | | Does anyone still use the 45 Degree Pallet
Electronics Forum | Tue Jun 17 15:52:51 EDT 2003 | russ
Is this a single sided or double sided board? We run the first side flat on the oven belt this keeps the board flat for the second side assembly. If the board warps during the second reflow process we will make a support fixture to carry the PCBA
Electronics Forum | Thu May 07 12:29:17 EDT 1998 | Rob Williams
I am running a board that is .062" thick and has components that over hang the edge of the board by .090". I have bottom side smt components (chip caps and resistors only) and use the turbulent wave to help solder the components. The problem I am h
Electronics Forum | Fri Jul 09 06:51:46 EDT 2010 | cobar
Try titanium edge stiffners on the PCB before making solder pallets.
Electronics Forum | Thu May 07 21:25:56 EDT 1998 | D.Lange
| I am running a board that is .062" thick and has components that over hang the edge of the board by .090". I have bottom side smt components (chip caps and resistors only) and use the turbulent wave to help solder the components. The problem I am
Electronics Forum | Wed Dec 10 10:05:07 EST 2003 | davef
We do not have experience soldering to the PVD surface you plan to use. We use Titanium [Ti] stiffeners in wave soldering and our wave equipment manufacturer uses Ti fingers, nozzles, pump blades, and other parts, because solder doesn�t stick to Ti.
Electronics Forum | Sat Dec 18 08:23:33 EST 2010 | remullis
I experienced warpage on a 7'x 13" long board, unfortunately my oven does not have center support. I use stiffeners on both of the short ends. It fixed my problem. Some of the things I was experiencing with the warpage on the second pass were placem
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
winsouce.jpg)