Electronics Forum | Mon Sep 14 18:40:39 EDT 2020 | dwl
A reflow oven with Center rail support can help. If your volumes are too low to justify spending $$ on a proper carrier, titanium stiffeners applied to the PCB before it goes into reflow is a cheap, albeit manual solution.
Electronics Forum | Mon Nov 02 23:12:13 EST 1998 | Kelly
We run stiffeners on all of our product through our wave solder process and most of our product through our reflow and adhesive cure oven. The problem is we continually put on and take off stiffeners because of poor reliability of stiffeners staying
Electronics Forum | Thu Apr 20 17:51:52 EDT 2006 | Geo
When we have warpage issues we use Titanium Panel Stiffeners even though the stiffeners are mainly used for Wave we find little issue for reflow. Mind you the boards have to be large enough.
Electronics Forum | Tue Nov 03 12:23:00 EST 1998 | Bill Schreiber
Kelly, How are you cleaning the stiffeners? The Smart Sonic cleaning process has been very successful in such applications. Visit the Smart Sonic Web Site at: www.smartsonic.com Or call me at 1(800) 806-440-R. Regards, Bill | We run stiffeners
Electronics Forum | Wed Nov 04 16:56:27 EST 1998 | Chris Lampron
| | We run stiffeners on all of our product through our wave solder process and most of our product through our reflow and adhesive cure oven. The problem is we continually put on and take off stiffeners because of poor reliability of stiffeners sta
Electronics Forum | Tue Nov 03 10:33:10 EST 1998 | Chrys
| We run stiffeners on all of our product through our wave solder process and most of our product through our reflow and adhesive cure oven. The problem is we continually put on and take off stiffeners because of poor reliability of stiffeners stayi
Electronics Forum | Fri Nov 08 14:19:59 EST 2019 | dwl
You can try putting titanium stiffeners on the PCB to prevent it from warping. How thick is your stencil? More paste would give you a wider window however too much and you risk bridging. You could try over printing the pad at the heel and toe to get
Electronics Forum | Thu May 07 12:29:17 EDT 1998 | Rob Williams
I am running a board that is .062" thick and has components that over hang the edge of the board by .090". I have bottom side smt components (chip caps and resistors only) and use the turbulent wave to help solder the components. The problem I am h
Electronics Forum | Fri Jul 14 11:34:37 EDT 2000 | Mike F
John, The first thing to check is how tight the boards are being held in the conveyor (assuming you are using a finger conveyor). They should be a little loose at the input end so there is some room to expand. If the boards are held too tightly, when
Electronics Forum | Thu Jan 13 13:16:40 EST 2000 | Dave F
Tony: You have choices: * Hi Temperature Tape: Go with Wolfgang ... too tough to control. * Selective Soldering Pallets: Some like 'em some don't. A lot of your success depends on the pallet fabricator. * Screenable Temporary Solder Mask: Wol
