Electronics Forum | Mon Jan 08 03:47:47 EST 2007 | tk380514
as someone had said before, check you stencil and have it redesigned. I design our stencils for my factory and have inproved quality in BGA , QFP and 0603 case sizes. we did have 1 prototype series that used 0403 chips btu we had brand new feeders an
Electronics Forum | Thu Jan 04 17:04:43 EST 2007 | slthomas
99% good solder joints = 10000 ppm (defects per million opportunities). Having only built with 0603s I can't speak for a target but that still seems pretty harsh....with a 75/25 0805/0603 ratio at my last place of employment I think we were running
Electronics Forum | Mon Dec 10 13:56:51 EST 2001 | slthomas
1) The additional activity of the OA flux probably took care of the oxydation. How do you plan on taking care of the presence of conductive and corrosive residues from it now, though? You're not supposed to wash those parts with water. 2) The tomb
Electronics Forum | Mon Dec 10 04:15:01 EST 2001 | Beny
Thanks for your advise Now I don't found Non-wetting defect at TIN COATED 0603 after I had increased peak temp and Time above 183 C. At film caps, I still found Non-wetting in high rate at film chip size 2416. I using PANASONIC's part with identif
Electronics Forum | Fri Dec 07 15:23:27 EST 2001 | davef
I'm with Brian. TIN COATED 0603 FAILURES Welcome to the lead-free generation. ;-) The Eurolanders are so blanking stupid, it just makes my head hurt. But then again, it doesn�t take much. OK, enough pontification. Your profile is setup incorrec
Electronics Forum | Mon Dec 10 16:44:51 EST 2001 | davef
Good for you!!! Similar to Steve's comments ... 1. NON-WETTING DEFECT: Yes. Your Lonco is a �stand and deliver� flux. Not some limp wrested impersonation of a flux like most nc fluxes. Without speculating about �incompatability�, recognize that
Electronics Forum | Thu Dec 06 23:34:25 EST 2001 | Beny
Pls. help. I�ve problem with non-wetting defect at capacitor termination. I have faced this problem at the 2 kinds of termination. One is chip capacitor 0603 that its outer termination surface composed with 100 Sn (Lead free) and another one is Sta
Electronics Forum | Tue Jan 17 11:52:07 EST 2006 | pms
Got a wierd one here, 0402's tomb-stoning. Scenerio---- Double sided PCB, paste both sides, 0402 on both sides. Reflow bottom side first--- no problems. Reflow topside next----no problems with topside components, BUT, the bottom side that was ref
Electronics Forum | Wed Jan 18 09:18:49 EST 2006 | samir
I had the same exact problem recently. I did exactly as the gentlemen said, and reduced the B/S zones 20 or so degrees, AND changed to medium convection. I'd like to point out that the B/S components still go liquidous (such is the Physics of convec
Electronics Forum | Fri May 01 14:00:59 EDT 1998 | Chrys
I've never seen this before. Today, I got this tombstoning on Tantalum Capacitors (Okay, I saw that before) Here's the part that seems weird to me: -They didn't tombstone onto a termination - they went onto their sides! That's right, both terminati
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411