Electronics Forum | Mon Dec 16 15:10:56 EST 2002 | Randy Villeneuve
We do not bake any of our boards prior to wave solder. If we did we would have one heck of a large oven. I would assume you are concerned about moisture sensitive components. In most cases your top side parts should only get to 80 degrees centigarde
Electronics Forum | Fri Oct 14 09:58:13 EDT 2005 | patrickbruneel
Here's what I believe is happening. The main difference between the HASL boards and the gold plated boards is that HASL boards are pre-soldered. HASL boards need very little flux activity to get good hole fill and the machine settings have a wide pro
Featured Article Return to Front Page REFLOW SOLDERING
Lewis & Clark | http://www.lewis-clark.com/product-category/selective-solder/
• Top side IR preheat • Nozzles: 3mm-6mm, 24mm mini wave • Manual load • Nitrogen capable • 16 x16 board size • Board warp compensation Complete and Operational USA Location Available for Immediate Purchase
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/divisions/efd/resource-center/solder-glossary-of-terms
through hole and surface-mount components to printed circuit boards by exposing the lower side to a wave of molten solder. Wetting The ability of a liquid to spread across a surface as opposed to drawing into itself. Wetting occurs when the attractive
.gif)
