Electronics Forum | Thu Feb 14 12:04:10 EST 2019 | slthomas
Can you take a picture of the front and back sensors? That might help me understand the situation. I wish I still had the visual images stored from 11 years ago but that ship has sailed!
Electronics Forum | Tue Feb 12 12:45:13 EST 2019 | aldrich17
Yes we do. I've done the R-axis sensor calibration multiple times in the past few weeks due to FNC Nozzle sensor errors, as well as R-axis errors. Do you suggest i go through the entire process of the Head Assembly Calibration? From section 15-1 thru
Electronics Forum | Tue Feb 12 14:13:56 EST 2019 | aldrich17
We executed that in IO screen all heads went down, N2323 sensor remained 0. And we cannot find N2223 sensor in the I/O screen. So now we are unsure of the issue but we are searching our manual in the "Placement Head" section hoping to come out with a
Electronics Forum | Wed Feb 13 16:27:28 EST 2019 | aldrich17
R axis is the rotation of the heads. 180 degrees and -180. The sensors tell the machine when the heads are switched correctly on the flying nozzles and the correct rotation. also i think they involve the clutch as well. After i make an adjustment to
Electronics Forum | Tue Feb 12 12:32:45 EST 2019 | aldrich17
Your response is helpful to a point. But unfortunately i can not confirm where the sensor is as i do not know what the A-table is. But i have checked sensors that i know of and one was not giving off a signal and fixed that issue. But now i am experi
Electronics Forum | Tue Feb 12 12:14:57 EST 2019 | slthomas
I haven't worked on a Topaz of any sort in over 10 years but I'm going to guess that even if you accessed that table, you would see a 0 someplace that you should be seeing a 1. It sounds like *maybe* an input signal from that sensor is not reaching
Electronics Forum | Tue Feb 12 12:47:02 EST 2019 | slthomas
Someone with some more definitive knowledge of these machines will no doubt chime in at some point, but my thought was that the "A-table" is just a data table that stores I/O information. Thus, being "off in A-table YV100X:N2323 YV100XT:n2223" just m
Electronics Forum | Fri May 10 01:42:13 EDT 2019 | vinitverma
A Table is something that you can ignore right now. It is significant only in case of dual table machines such as Sapphire or Sapphire-X which have A and B tables (two independent PCBs being handled at the same time). In case of Topaz or Topaz X or E
Electronics Forum | Fri Nov 18 02:42:46 EST 2005 | vinitverma
Greg, I recently faced this problem at a customer though the machine was Topaz X but the problem was same. So I suggest you first check if the GOOD LED is ON on the Servo card down in the MCX box. Also check the same GOOD LED on the System board in
Electronics Forum | Tue Jun 09 04:48:13 EDT 2015 | vinitverma
What axis does it show in the error?