Electronics Forum | Wed Feb 13 14:35:57 EST 2019 | aldrich17
we do see some inconsistencies with fiducials. We use X, Y references in the machine but still find them with the camera to populate pcbs. But just can't always center the cross-hairs in the fiducial. Most of the time we have to offset the cross-hair
Electronics Forum | Fri Apr 24 10:58:15 EDT 2015 | chris_jayconsystems_com
I have checked and rechecked all my dimensions on the capacitor which is a 402 size. The manual says that the center is incorrect. Need some help to figure out why it is throwing this part away seeing it passes a vision test. Any help would be gratef
Electronics Forum | Wed Feb 13 15:12:09 EST 2019 | slthomas
The reason I asked about using X-Y data (originated from the pcb files) is that if you bombsite the locations with the camera and program or adjust them individually, you run the risk of having to do it over and over when fiducials change, your fixtu
Electronics Forum | Wed Feb 13 14:15:06 EST 2019 | slthomas
I don't see any attachments.....? Are the fiducials consistently well finished (perfectly round, shiny without splotches or other imperfections), or do they vary in quality? When you do a fid offset, is the correction consistent or do you get varie
Electronics Forum | Wed Feb 13 11:23:14 EST 2019 | aldrich17
We have several issues with components placing properly onto designated leads without having to offset our boards fiducials before population. For several of our boards, we cannot set our fiducials "dead center" but rather offset them in various dir
Electronics Forum | Thu Feb 29 13:42:53 EST 2024 | mistrthou
I'd be looking at the safety circuit as a whole. Grab a multimeter and make sure you get a full closed loop back to the safety relay, and see if the safety relay itself didn't go bad.
Electronics Forum | Thu Feb 29 17:50:55 EST 2024 | compit
I don't know if it's the same in the XII series, but in the X series the emergency signal also passes through the electronics board on the head, cards in the computer, etc. - through ALL elements of the machine.
Electronics Forum | Wed May 08 10:21:05 EDT 2019 | compit
During the start the error "DOWNLOAD VISION ERROR" - instead of "OK" is "NG". - resolved - video card died. But I still have a motor overload error Y1 (L057:CUR.DEV ... Y1 error) - what resistanc
Electronics Forum | Mon Apr 27 11:29:06 EDT 2015 | chris_jayconsystems_com
When I do the adjust to make sure the vision and tolerance is working it works perfectly. But if the machine runs a board I am riddled with this. I have checked the vacuum levels on all the heads and they are within where they are supposed to be for
Electronics Forum | Fri Aug 03 01:44:38 EDT 2007 | pavel_murtishev
Good morning Steve, What does optimizer say? What is the error generated by optimizer? Could you tell me exact error optimizer gives? Topaz ties to fit all feeders mechanically into the feeder plate when optimization starts. Optimizer generates an
winsouce.jpg)
