Electronics Forum | Thu Feb 29 17:50:55 EST 2024 | compit
I don't know if it's the same in the XII series, but in the X series the emergency signal also passes through the electronics board on the head, cards in the computer, etc. - through ALL elements of the machine.
Electronics Forum | Wed May 08 10:21:05 EDT 2019 | compit
During the start the error "DOWNLOAD VISION ERROR" - instead of "OK" is "NG". - resolved - video card died. But I still have a motor overload error Y1 (L057:CUR.DEV ... Y1 error) - what resistanc
Electronics Forum | Mon Apr 27 11:29:06 EDT 2015 | chris_jayconsystems_com
When I do the adjust to make sure the vision and tolerance is working it works perfectly. But if the machine runs a board I am riddled with this. I have checked the vacuum levels on all the heads and they are within where they are supposed to be for
Electronics Forum | Fri Aug 03 01:44:38 EDT 2007 | pavel_murtishev
Good morning Steve, What does optimizer say? What is the error generated by optimizer? Could you tell me exact error optimizer gives? Topaz ties to fit all feeders mechanically into the feeder plate when optimization starts. Optimizer generates an
Electronics Forum | Thu Feb 29 02:24:55 EST 2024 | redspare1
Strange error, I have looked at the schematic and checked all of the e-stop switches and they're good. The machine isn't connected to anything, but air and power. Has anyone else seen anything like this? 1. When pressing the active button it beeps
Electronics Forum | Fri Sep 14 02:59:09 EDT 2007 | saab
Out of curiosity, I measured the vacuum levels on our Topaz. With a #31 nozzle the values read somewhere between 130 and 150 when open and about 200 when blocked. The component pickup works fine with no errors with these values
Electronics Forum | Tue Oct 04 05:01:00 EDT 2016 | ok66
Hello! Need help! We have Topaz Xi. Need to place QFP176 (26mm). When optimizing the error E0194 (Component will interfere with other nozzles). Need to turn off one nozzle, don't know how to do it. Сan You help us?
Electronics Forum | Fri Dec 15 11:01:14 EST 2017 | robertorocco
I have one Topaz X FNC machine with this problem. The head 2 FNC not change the nozzle. The head 4-6-8 is ok and change, but head 2 no, when he tries to change the nozzle he gives me an error message. What could be the problem?
Electronics Forum | Tue Feb 21 10:45:45 EST 2012 | acsscott
Thanks for the password. There is a 7 pin connector for the Emergency stop in and out. It has a mate with a jumper wire attached to the Topaz end. If you put the jumpered mating connector on this, the emergency stop errors go away. The other conn
Electronics Forum | Sat Oct 06 15:00:42 EDT 2012 | chrisnims
We bought a used 1999 topaz x and are trying to get it up and running. unfortunately we are getting an error: Anyone know where i can get a service manual or having any idea where to look to resolve this problem? "E229" “Nozzle down limit sensor is
