Electronics Forum | Wed May 08 10:21:05 EDT 2019 | compit
During the start the error "DOWNLOAD VISION ERROR" - instead of "OK" is "NG". - resolved - video card died. But I still have a motor overload error Y1 (L057:CUR.DEV ... Y1 error) - what resistanc
Electronics Forum | Tue Feb 21 10:45:45 EST 2012 | acsscott
Thanks for the password. There is a 7 pin connector for the Emergency stop in and out. It has a mate with a jumper wire attached to the Topaz end. If you put the jumpered mating connector on this, the emergency stop errors go away. The other conn
Electronics Forum | Thu Jun 29 18:13:00 EDT 2023 | bobpan
here is the error.....looks like plus limit error
Electronics Forum | Fri Aug 03 01:44:38 EDT 2007 | pavel_murtishev
Good morning Steve, What does optimizer say? What is the error generated by optimizer? Could you tell me exact error optimizer gives? Topaz ties to fit all feeders mechanically into the feeder plate when optimization starts. Optimizer generates an
Electronics Forum | Mon Jan 08 19:52:14 EST 2007 | fastek
A soft limit error is an error due to trying to drive the head outside it's mechanical limits. Check your X-axis program data for this part.
Electronics Forum | Tue Feb 09 12:15:14 EST 2010 | rajtaware
Check if the feeder position is out of picking area mentioned in manual. Change the feeder position.
Electronics Forum | Tue Feb 09 13:27:05 EST 2010 | duchoang
Re-optimize the program. One (or more) head(s) can not reach and pick up parts from certain feeders.
Electronics Forum | Mon Mar 05 21:55:59 EST 2012 | vinitverma
Please describe the problem in a bit more detail like what is the size of the components in both the charges? It is possible that the size is a limitation here. What nozzles are used for all the 8 components in the component information?
Electronics Forum | Wed Dec 07 02:35:28 EST 2011 | mk15
Hi, I am looking for help with Error Philips Comet, Start Procedure -OK, INTIAL SERVO ORIGIN -OK, AUTORUNNING -OK, PCB START -OK, FIDUCIAL -OK, PICKUPCOMPONENT -OK, NEXT-ERROR E2 CORRECTION DATA ERROR(CORRECTION DATA IS NOT LOADED OR FAILED TO ADJU
Electronics Forum | Wed Jan 19 11:44:47 EST 2011 | davemac62
I have a Topaz with 2 positions in the rear where component trays may be placed for limited tray component capability. There is not a lot in the manual on how to set this up. The Feeder Plate info is set up to allow Fix.tf. I have spec'd tray - fix.t