Electronics Forum | Sun Jun 18 13:15:57 EDT 2000 | Kevin Simpson
HI, We have placed with both Fuji Qp's and Universal Gsm's. We are running a small coil now on a Gsm with a sucessful rate.The Qp done well also, but the product is not ran on a Qp line, so no true production rate has been determined.I don't feel
Electronics Forum | Wed Oct 24 11:06:08 EDT 2007 | slthomas
While many here would probably shoot themselves at the thought, I'd recommend a Quad IVc. You can't get much smaller, they're easy to set up, easy to operate, and for the most part run pretty much forever with minimal maintenance because they're so m
Electronics Forum | Wed Dec 29 18:01:13 EST 1999 | JAX
What's happenin Larry, I am not sure if bump proccess E is available on this particuliar software rev. but I have forgotten?????? It shouldn't matter; bump proccess A will work fine. The only things you have to do is make sure the pick up point
Electronics Forum | Tue Jul 02 08:59:14 EDT 2002 | jax
On an IP3, from what I remember, the BGA Part data is defined from center part moving out towards part edge. If your pick up point is a little off this problem can occur. Otherwise, Check your gain and offset settings. The machine is probably recogni
Electronics Forum | Mon May 04 14:24:12 EDT 2009 | jimmyboz
Ok, So, If all the servo amps on H1 remained on H1 and the amp you changed is on H2, I have to guess the shifting on H1 is unrelated to the servo prob. Is the shifting unsolderable? if it just looks bad but will reflow, it may have been occurring f
Electronics Forum | Fri Sep 07 14:51:36 EDT 2001 | Claude Couture
What kind/brand of machine are we talking about? Are the missing parts randomly distributed or are specific to a feeder/placement/pattern? Does your machine remember where to resume placement if you reset it in the middle of a pattern placement? We h
Electronics Forum | Wed Jul 29 17:43:26 EDT 1998 | Steve A
| Hi, good friends | I found this site is so wonderful to learn SMT techniques meaningfully. | We now employ 3 Fuji GL-541 dispensors and raw material with Soma IR-120. but we found glue string casually. From my experience from trouble-shooting the c
Electronics Forum | Wed Aug 01 15:18:40 EDT 2018 | dleeper
One option might be to convert the coil to through hole and use intrusive reflow AKA pin in paste. the coil leads would have to be formed perpendicular to the board instead of parallel. you would have through holes instead of SMT pads, but you would
Electronics Forum | Wed Sep 16 16:03:36 EDT 1998 | Ben Salisbury
| | | Has anyone used Fuji's rubber tip nozzles for the IP3? Are they O-ring type or suction cup? I'm having trouble picking up Ompacs due to the top of the part not consistently being flat. Any actual experience with these $1100 nozzles would be a
Electronics Forum | Wed Mar 28 09:25:53 EDT 2007 | SWAG
Yes, pre-loaded feeders is the best way. If you do not have that option as you are high mix or do work for different companies that have many different part numbers, I would guess that your printer will take about 15 minutes to get ready, each HSP f
.gif)
