Industry Directory | Manufacturer
Radiotronix set as its goal to create a new generation of highly-integrated IC-style RF module that combined ease of use, enhanced performance and lowered customer cost.
Electronics Forum | Tue Dec 21 17:15:49 EST 2021 | vtdivtecs
yeap I was able to figure it out and avoid my head being on a stick anywhere. if you log out of tpsys and into hw config you can turn off the hydra head there, then unplug the hardware and the machine will run. if you just disable it inside tpsys t
Electronics Forum | Fri Mar 06 14:33:53 EST 2020 | bk
Another thing you can check is where the bar comes down off of the hydra z motor there is a little bearing you can see from the front make sure that bearing is turning even oil it up a little. You can also adjust the tension by loosening the tiny set
Electronics Forum | Thu Dec 21 17:04:28 EST 2023 | cyber_wolf
Disable the hydra head.
Electronics Forum | Thu Mar 05 07:40:55 EST 2020 | tomdegas
I swapped the mi boards with ones from a working My12 machine and the same results. To recap my problem: On "Hardware Initialization" the center jaws open and close, the Hydra Theta belt moves back and forth, the Hydra head moves all the way down an
Electronics Forum | Thu Dec 28 20:46:49 EST 2023 | padawanlinuxero
I was use to work with the machine but it has being several years since I had one in my hands, but i got the same error message, I kinda remember there are some sensors in the top part of the hydra try to see if theres dirt or something not letting t
Electronics Forum | Sun Dec 17 13:52:59 EST 2023 | tomdegas
How can I bypass the " Hydra force sensor can't calibrate" during the "Hardware Initialization" test. This is stopping me from starting the machine.
Electronics Forum | Thu Feb 01 14:57:05 EST 2024 | cflames17
Have you tried reinstalling all the tools? This appears to be a problem with the tool bank being out of tolerance. Reinstall each tool in your tool bank one by one. Are the hydra tools ok?
Electronics Forum | Thu Jan 05 12:33:30 EST 2017 | rgduval
If you haven't resolved this yet, I think you're going to want to go to either the part or the package (I'm not sure which one off hand), and make sure that the hydra heads/tools are selected for placement. You'll also want the vision set to the lin
Electronics Forum | Wed Nov 09 05:44:06 EST 2005 | grantp
Hi, It sounds like your vision is not setup right for this component, and it's rejecting some of them because they would be failing the test. This brings up a point we discovered. Don't use auto teach for the component if your using HYDRA or vision
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411