Electronics Forum | Tue Aug 24 17:59:10 EDT 2010 | davef
A board support must be used to prevent bowing of the board during insertion of the sockets. It should have a flat surface with holes or a channel large enough to receive the sockets during installation. [Tyco AUGAT HOLTITE Socket Application Note 11
Electronics Forum | Fri Oct 17 15:23:28 EDT 2014 | davef
First, don't exceed the maximum temperature of the battery, say 85*C [I don't know your specifics] Second, don't short the terminals of the battery. Third, the best way to wave solder a battery is: * Insert an insulating tab between the battery an
Electronics Forum | Mon Jul 13 12:45:54 EDT 2015 | antoine_fradette
i am looking to buy a pressfit machine, but i really don't know much about them. I wanted to know which one would work with theses tools. the molex tools are the most important molex: insertion:62202-9940 extraction:62203-0150 molex: insertion:622
Electronics Forum | Tue May 29 16:02:36 EDT 2001 | genny
500 insertions � 50 m gold => 300 insertions � 30 m gold => 50 to 75 insertions � 20 m gold => 10 insertions. " Dave stated that the 'm' referred to micro-inches. I could probably insert this board 1000's of times without a problem. Am I missing so
Electronics Forum | Thu Aug 30 07:22:31 EDT 2007 | jdengler
The dedicated fixture never really wears-out. You may need to change tooling pins and hold-down tabs, but it will still be accurate when we are all long gone. The adjustable fixtures seem to wear-out. Depending on usage and care it may go from 3 y
Electronics Forum | Thu Apr 24 10:04:25 EDT 2003 | paul_bmc
I have been trying to keep up with these machines for years and ever since Multitroniks was acquired by tyco the support has disappeared. I can no longer buy parts or get service for these machines. Is there anyone out there that may know of a comp
Electronics Forum | Fri Feb 04 16:24:00 EST 2011 | snigro
Rodrigo I am the service manager of Mirtec. When your using ATT It tries to match the saved image to what is on the board. If the area isnt a good match, it will not program the part. At the bottom of the ATT window, select the tab labeled 'mmd file
Electronics Forum | Thu Apr 30 09:27:58 EDT 2020 | clockwatcher
I currently have a board that has several wires that need to be soldered into it. Many years ago I remember wave soldering power supply boards that also had many wires. In order to keep the wire insulation out of the solder fillet and keep the wires
Electronics Forum | Thu Sep 01 11:17:52 EDT 2005 | chunks
There are many rules, but balance is the key. It all depends on your processes, type of equipment you plan to run the panel through, as well as the type of components going onto the board. If your single up circuit has 6 thru-hole caps, 5 connector
Electronics Forum | Tue May 29 12:35:36 EDT 2001 | genny
Dave, Sorry to drag this out some more. When I saw this thread I realized that we often get PWB's fabricated with a gold plated edge connector tab. However we have not ever given any specs to the fabricator regarding the gold plating - all we say i
