Electronics Forum | Tue Aug 21 08:44:48 EDT 2001 | caldon
A) The standoff height of some uBGA components does not allow water to penatrate under the component. B)Water soluable may dilute the flux and not remove it all together. This can be tested with Ion Chromatography. C) Water soluable in some cases ne
Electronics Forum | Mon Mar 25 21:50:10 EST 2002 | davef
Some of this was copped from Fred. There are numerous package types that now fall under the rubric of land grid array [LGA]. Land grid devices [ie, Bumped Chip Carrier� [BCC], LGA, Quad Flat-pack No-lead [QFN], MicroLeadFrame�, etc] are essentially
Electronics Forum | Thu Mar 27 18:07:02 EDT 2014 | hegemon
If you are 100% sure that the solder has reflowed (time and temp based), then just use an wood stick to wedge the part upwards. It just takes a little bit of "lift". I used a wooden Q-Tip end that I trimmed to a wedge using an exacto blade. Wait f
Electronics Forum | Wed Jun 30 18:02:53 EDT 1999 | Mark
| What is the best way to re-ball a BGA? Who has the best system for doing it? | To RE-Ball an IC you must re-BALL the IC! The idea of using a stencil to deposit all of the appropriate solder mass can not work. Here is the process (minus the app
Electronics Forum | Thu Sep 23 02:52:21 EDT 2004 | johnwnz
olks, got one for you. What is the feeling on reusing SMT components that you have removed from an assembled PCBA? For example, you place your IC's and they are 180 deg out, you have to remove them.... but what about refiting the same devices? Are t
Electronics Forum | Fri Feb 20 08:56:42 EST 2004 | davef
We successfully clean WS flux on 1mm and 1.25mm pitch BGA. For 0.8mm pitch BGA, we use no clean, because we cannot remove the flux residue from under them efficiently. Use ion chromatography testing to be sure it is clean under the BGA. IC is the on
Electronics Forum | Sun May 21 09:38:25 EDT 2006 | davef
Epoxy Removal and IC Delidding [Hardware Hacking: Have Fun While Voiding Your Warranty, Chapter 14] Encapsulation of critical components using epoxy or other adhesives is commonly done to prevent tampering and device access (the microprocessor shown
Electronics Forum | Mon Oct 14 12:56:50 EDT 2002 | davef
His technical contribution to the forum. From these 24 postings, we can see that 75% of Sean�s postings have a decided commercial bent, as followings: * Could be argued that the posting is a good technical response. Percent of postings 25%. * Could
Electronics Forum | Mon May 25 04:51:44 EDT 2009 | microdot
hi, we tried making a profile of a chip ATI 9000 mounted on a toshiba laptops, this is on a small pcb. the picture i have enclosed is used to remove the but when we tried to solder the chip using the same profile..it didnt work. Can anybody suggest
Electronics Forum | Fri May 15 14:41:25 EDT 1998 | Terry Burnette 512-933-5783
| We had some failures on an IC package that the manufacturer has put down to moisture inside the package, leading to popcorning. | This seems a bit odd, the package is a PLCC 84 which is quite thick. I have only seen this problem on thin packages. |