Industry News | 2018-12-13 03:35:05.0
Pick And Place Machine
Industry News | 2012-02-23 16:34:02.0
Aegis Software will unveil its exciting new nForce product at APEX 2012. Visitors to the booth will see first-hand how nForce provides users with a simple, yet extremely powerful process assurance solution for best-in-class factories.
Industry News | 2021-11-24 20:10:19.0
The development of "intelligent factory" has put forward a new direction for manufacturers. It is necessary for manufacturers to master the production and marketing process clearly, make production process easier to control, reduce the manual intervention with the production line, collect timely and correct production line data, and make production scheduling and planning more reasonable. All of these are of vital importance to improve competitiveness and productivity of manufacturers.
Electronics Forum | Sat Jan 29 12:01:32 EST 2011 | jts142
hi i am having problems with a cp 643 when i run in auto it errors unloading a board with the x axis servo interlock error but if i hit sequence end stop so that it stops after every board it runs and unloads perfectly. Any hints or suggestions we ha
Electronics Forum | Tue Feb 01 13:21:34 EST 2011 | cyber_wolf
Try switching to a different board and see if the error goes away. If it does, it has something to do with one of the loader sensors not being made.
Electronics Forum | Tue Nov 15 19:31:54 EST 2005 | eeltec
>I/OPERATION ==> >1/RUNNING ==> but any command that I try gives an E100 error and in the left side of the monitor a square with: Conditions Initialized Waiting Emg stop (in red) org incmp (in red) Interlock (in red) data comp Use Vac
Electronics Forum | Thu Aug 29 05:01:38 EDT 2013 | bobpan
Motor Error 5 is usually an interlock error. Take off the rear right cover and look at the red and green led's on the driver cards. If they are both lit....you have a door open or if you have carts....a feeder base switch is up. Good Luck
Electronics Forum | Mon Jun 16 11:36:28 EDT 2014 | bobpan
Are both red and green leds on for the driver cards (they are located in the bottom right of the machine). If they are both on then you have an interlock opened. If this is the case....check the side doors....sometimes they are not shut all the way.
Electronics Forum | Mon Jan 15 11:12:08 EST 2007 | jaimebc
I've had experienced this issues here with our GSM's Flex heads. Try this: 1.- Clean your linear scales with alcohol and a lint free cloth. Both the X and Y. This one has fixed the majority of our errors when one of the heads just stops for no apare
Electronics Forum | Thu Jul 30 08:46:12 EDT 2015 | hemantp
We are having X-Ray Machine X TEK HMXST-160 The machine is working fine with respect to Interlocking , X-ray on , but not able to zoom and move the Joystick positions ,it is stand only in one position while starting the application we are getting
