Electronics Forum | Thu Mar 01 19:23:41 EST 2007 | SWAG
I could be wrong but I think the use for alternate feeder axis is a way of stopping the carriage so it does not always return to home every time an error condition exist. Saves on time and wear and tear on the machine. As for alternate carriage, I
Electronics Forum | Tue Jun 26 08:47:09 EDT 2007 | geb
Hi we have a Universal GSM 1 flex head machine. It keeps on bringing up an "Axis Head 1 Z velocity over speed error during move absolute command". Pushing the e-stop button and then start again will allow it to continue making the panel. It happens r
Electronics Forum | Tue Oct 01 18:44:24 EDT 2013 | richardconnell
Hi, I have limited capability on the Z axis. The axis will home to the mechanical switch limit and then drop to a point which I asssume to be the fiorst zero point below the mechanical switch limit. Then it gives the error. There is power to the mo
Electronics Forum | Mon Sep 30 16:36:00 EDT 2013 | richardconnell
I have a Universal Instruments Corporation TAB Bonder. Oldish machine. Initial fault on machine : - "Axis Head 1 Z DAC Limit error during move absolute command" Other fault seen after we reset power, Zeroed axis etc. - Axis Head 1 - Z error not re
Electronics Forum | Tue Oct 01 17:56:10 EDT 2013 | swag
I'd take a look at the power supply for the failed axis and see if it's still working. I've also seen encoders fail on motors but it's rare in my experience. Usually it's a power issue.
Electronics Forum | Sun Sep 18 15:00:33 EDT 2022 | superlen
Poly, Yes. I took a tangent on you. When I read your initial post I was thinking axis err. Still good points for the Genesis but won't help your current problem. :) Len
Electronics Forum | Tue Sep 06 01:32:25 EDT 2022 | poly
I've got two Genesis machines (GC30 and GX11) that I bought used. The PWC on one is disabled, and if I enable that axis the machine will tell me it can't find or initialise that axis. I tried swapping the board 48904905 from the working machine to th
Electronics Forum | Wed Nov 14 19:33:20 EST 2018 | reckless
When trying to save a program onto a floppy disk I get this error on the screen. The file was being continuously saved on HD but when I tried saving on the floppy as a backup all data was lost and there was no way to recover original file. What k
Electronics Forum | Sat Apr 29 12:18:07 EDT 2023 | poly
I have finally got a calibration kit for my single beam multi function Genesis. Calibration finishes successfully, I then attempt to pick a part with the 7 spindle head and it gives me a collision error. The error occurs even when I don't have a no
Electronics Forum | Sun Sep 18 06:17:40 EDT 2022 | poly
I'll double check tomorrow but I don't think so, it fails zeroing straight away (without moving the other parts) when the PWC axis is enabled, which is why I tried swapping the board as I assumed it was a controller not being found issue.
