Electronics Forum | Wed Jun 08 19:18:43 EDT 2022 | fuji_user_2014
I'm having some issues with lead time with my current fabricator of work board holders for my Universal THT machines (I won't name names). I've been waiting for a couple of months on some of my orders from them. My machines have a standard rotating t
Electronics Forum | Thu Sep 02 13:19:52 EDT 2010 | remullis
I am having issues with the air dump on this machine. When you palm down or break interlocks the air dumps as it should however I'm getting a short burst of air back through the system. The problem with this is it's just enough to trigger the table l
Electronics Forum | Tue Apr 11 13:01:36 EDT 2017 | mrich208
Yes Sir, someone had replaced the fuse with a resistor and it had burned up. We had an exact board on the VCD. We swapped them and it worked! I am not sure how this forum works but now the machine will zero and say it's missing a part but the sequ
Electronics Forum | Mon Mar 05 07:53:28 EST 2018 | wolverine55
Hello All We have a Universal Model 6287A that is estimated to be about 25 years old. It has run fine for most of it's life but recently has stopped communicating with it's host computer, whenever any commands were attempted to be sent to the machine
Electronics Forum | Thu Jul 28 15:43:48 EDT 2016 | ddina
Recently started setting up our GSM 4681A system, and one of the machines comes up with the message "WAITING FOR OUTPUT BOARD TRANSFER TO COMPLETE" after the Zeroing process has been started. Machine has all the defaults set, two SMEMA connected univ
Electronics Forum | Mon Sep 30 16:36:00 EDT 2013 | richardconnell
I have a Universal Instruments Corporation TAB Bonder. Oldish machine. Initial fault on machine : - "Axis Head 1 Z DAC Limit error during move absolute command" Other fault seen after we reset power, Zeroed axis etc. - Axis Head 1 - Z error not re
Electronics Forum | Fri Sep 25 20:11:58 EDT 2015 | ercdave1
Thank you for taking the time to read this post. I hope I can get some help since I am at the point where I don't know what to do. I have a Q block Universal GSM2 having some issues. I am getting an error message that reads. "spindles Not seen for
Electronics Forum | Tue Aug 07 20:51:43 EDT 2001 | davef
Sowaza BIC? Ru the ball point pen people? Know no sites, like thet, but let�s see what we can do here. Wedabomb. First, rather than defining the controls your suppliers must use to produce your product, why not specify a DPMO rate er suppin like t
Career Center | Clearwater, Florida USA | Maintenance,Production,Quality Control,Technical Support
I have approximately 14 years experience in the Electronics manufacturing industry. I have experience from manual assembly to machine technical support for SMT eqiupment. I also have some experience with AI equipment. I have Automatic Optical Inspect
.png)
