Electronics Forum | Tue Jan 23 17:32:53 EST 2007 | russ
if you cannot spend any money I would say that you either need to add rails or try to increase the squeegee pressure to hold down the stencil while it prints those close pads. But...... Can you put PCB onto some type of carrier that would move thes
Electronics Forum | Wed Jan 24 08:22:18 EST 2007 | cyber_wolf
Turning off the grid-lok is not an option. I have used the hand inserted tooling in the past..It takes too long to set up and it does not accomodate warped boards. So I am I safe in saying that there is not much I can do aside from change my board d
Electronics Forum | Tue Nov 25 18:39:59 EST 2014 | rhcriad
We have an MPM UP2000 stencil printer and have a lot of issues with burned out 6410 driver cards (or driver cards just failing to work). I have looked over these threads and found that this is a common issue with these cards. I understand that thes
Electronics Forum | Tue Sep 05 16:26:53 EDT 2006 | Bill
Thinking about this auto-mode on Grid-Lok..... Ok, the board is warped, lets say positively, the pins conform to the warped board... what about the effect on top side and squeegee pressure? It will be much higher and could damage stencils, right? Pos
.jpg)