Electronics Forum | Thu May 09 10:37:35 EDT 2019 | slthomas
Disclaimer - I know nothing specific about MPM printers. First, a question - have you successfully printed or programmed a print cycle for any other board yet, or is this the first one? I ask because a board stop sensor error sounds like it could b
Electronics Forum | Wed Sep 26 07:40:30 EDT 2012 | highmillr
I had this problem at another plant with the UP 2000....When the machine resets, The left and right side of the conveyor misaligns, causing the conveyor to be tight on the loading end and boards falling out of the unloading end. or vise versa...the t
Electronics Forum | Wed Apr 13 04:09:15 EDT 2005 | simmcircuits
Hi, I need help with our MPM UP2000, the stencil and the lamp boards won't turn off completely, they are both on at the same time. Turning it on would only make it brighter, turning it off will just lose the brightness but the lamps are still on. I h
Electronics Forum | Fri Aug 07 09:53:12 EDT 2009 | kpm135
The Z-axis Drive card on our MPM UP2000 HiE fried. We replaced it with a new card, setting all the jumpers to match the old card. After that we had to recalibrate the Z-axis and the snugger height but the problem is that the camera is now too close t
Electronics Forum | Mon May 02 11:00:34 EDT 2005 | jh0n!
Unfortunately, we don't have that option under Utilities. Must be UP-2000 specific. I've set everything up correctly, multiple times...All the right dimensions, etc, taught fids, and it still tries to load the board in the wrong position. As far a
Electronics Forum | Tue Mar 25 08:35:49 EST 2003 | pjc
AccuFlex is the replacement for UltraPrint 1500. UP1500 is going obsolete. AccuFlex was desgigned for fast setup and changeovers and takes some tasks away from the operator. The UltraPrint 2000 was designed for high production, even though many users
Electronics Forum | Mon Jul 29 09:19:00 EDT 2002 | pjc
Quick Change Tooling is one advantage for DEK when comparing the MPM UP2000. DEK has Form Flex. Good system, but I've heard concerns about long term dependabilty. All support tooling options offered on the UP2000 takes a bit of time to set up. So, If
Electronics Forum | Tue Aug 15 10:55:23 EDT 2006 | chrisgriffin
Some software versions won't allow a brightness change with the next button. You should do a histogram test. Place a board on the worknest, then a smooth white card on top of that. Then jog the camera over the card. Raise the Z-axis to it's softwa
Electronics Forum | Wed Jan 24 11:22:46 EST 2007 | pr
Do you still have the vacuum plates in? If so, you can set the grid-lok up in the "fixed mode" (not sure what they call it,where it won't set for each board), then you could run without side clamps and the Vacuum should be enough to keep it from movi
Electronics Forum | Mon May 02 10:49:10 EDT 2005 | pr
We are using a UP2000 so I'm not positive on this but.... The squeegee stroke will have to be taught by and the software will walk you through setting the stroke. What do you mean by "where it drops the pins to load/unload/locate"? If you follow th