Electronics Forum | Tue Feb 06 16:36:51 EST 2018 | dontfeedphils
For anyone looking back on this post, I ended up figuring out something that will work for my process. Jack up the atomization pressure on the guns, lower material flow, quicker-lighter coats, less time between coats, and more coats. Smooth, even f
Electronics Forum | Tue Sep 21 10:16:28 EDT 2004 | davef
Check with your connector supplier, but most press-fit contacts will pierce through Types UR & XY conformal coat (military approved). Acrylic (AR) Urethane (UR) Epoxy (ER) Silicone (SR) Parylene (XY)
Electronics Forum | Fri Sep 09 15:03:46 EDT 2005 | Amol
Hi, I am running a circuit board that needs a part to be put on it after cleaning and before conformal coating. the only problem is that after cleaning and hand assembly of the part, there is a thin whitish residue in the ckt board that one can see w
Electronics Forum | Thu Feb 01 07:41:01 EST 2018 | dontfeedphils
Interesting, never heard of using wax as a coating mask. Not sure how well the AR coating would hold up to a hot alkaline wash (unless you have experience with it), but that stuff usually starts to flake off/de-wet if you just look at it wrong. I'm
Electronics Forum | Thu Feb 01 09:09:10 EST 2018 | deanm
I'm not sure if your customer will allow it but consider sealing the perimeter of the connector where it meets the board with some kind of sealant or staking material. Cure it then apply tape on top of it. Then all you have to do is remove the tape a
Electronics Forum | Thu Aug 31 08:29:21 EDT 2006 | GS
Hello, which is the most reliable and suitable resin (AR, ER, UR, SR) to coat automotive Assembled PCB (PBAs) ? Your experience and advices will be appreciated. Thank you Best Regards...........GS
Electronics Forum | Wed Jan 31 10:56:23 EST 2018 | dontfeedphils
I'm working on bringing up a new conformal coat process/workcenter and have a few questions I'm hoping someone might have experience with. Right now we're manually spraying both coating materials (1B31 and 1A33 from Humiseal) using HVLP guns. I run
Electronics Forum | Tue Feb 18 13:08:05 EST 2014 | hegemon
Paralene, Paraxylene, or other vacuum deposited coating will require this method to remove the coatings. UR and Acrylics have solvents, as Rob above has mentioned. Plastic bead media and wheat chaff are ones that I know have been used for Paralene
Electronics Forum | Wed Apr 18 21:35:26 EDT 2007 | davef
Thermal conductivity [W/m-*C] * Conformal coating [AR, ER, UR]: 17-21 * Epoxy molding compound: 0.6
Electronics Forum | Wed Apr 19 11:50:05 EDT 2006 | amol_kane
Hi BJ, Everyone's favourite answer...it depends! If the volume if large, masking boots will save you both, time and money in the long run. Custom boots are relatively expensive to buy, but they pay themselves over time by savings on masking tape. ma
