Electronics Forum | Thu Jan 28 10:09:51 EST 1999 | Charles Stringer
| | | | Greetings, | | | | | | | | Can anyone tell me what temperatures pcb's should have when coming out of a forced convection reflow oven and out of a wavesoldering machine. | | | | Also, is there any danger of the pcb's giving off some kind of g
Electronics Forum | Mon Mar 19 09:37:01 EDT 2018 | spoiltforchoice
Another critical part of a process with a large board is support. Most commonly this is a bed of pins e.g something like red-e-set but there are other solutions. Support with a large panel will be critical for printing to get a good gasket between PC
Electronics Forum | Mon Jun 27 12:02:47 EDT 2022 | proceng1
I have never used a VP oven, but I did get a pretty good demo of one and was pushing hard for my company to acquire one. The issue ended up being that there was not an East Coast distributor for the "juice" and that became cost prohibitive to get sh
Electronics Forum | Mon Oct 21 22:15:36 EDT 2002 | davef
First, SIR data is heavily dependant on the test pattern selected. Be very careful when comparing the results of resistance readings taken from different geometric patterns. Second, if yer talkin': * Bare boards, yupper. * Finished assemblies impor
Electronics Forum | Thu Mar 30 21:46:56 EST 2000 | Dave F
Reg: This is copy / paste from draft version of IPC 7095 ( issued May 1999 ) ... 7.3 Assembly accept/reject criteria 7.3.1 Voids in solder joint a. Sources of Voids There can be voids in solder balls, or at the solder joints to the BGA, or at the so
Electronics Forum | Tue Apr 17 09:38:04 EDT 2001 | CAL
With some help from our good Friends at Agilent Technologies our RF Lab includes testing up to 100GHz. Equipment includes Vector network analyzer, signal analyzer, dual channel power meter, noise filter meter, advanced impedance analyzer (including
Electronics Forum | Tue May 15 21:57:06 EDT 2001 | davef
Welcome!!! Where the hay ya been??? Sorry bud, were lining-up with your fab [it hurts me to say that, but when yer ] We used to dry pack with desiccants, also. Its probably an old MIL-STD-2073-1C requirement [er something like that]. We qui
Electronics Forum | Tue May 19 12:29:59 EDT 1998 | Richard Jackson
| Richard, | You may be encountering solder paste contamination | on the assembly during the printing process. Solder | will reflow on tin/lead plated lands therefore invisible. | If you are washing the assembly prior to inspection | then you are