Electronics Forum | Tue Aug 17 03:03:56 EDT 2004 | soease
thank you Grant and dreamsniper for these shared experiences; I think I'll still try some vapor phase just to have a look to this process, but will focus on a convection as long as it's the actually chosen technology in the company and that it's expe
Electronics Forum | Mon Aug 16 20:19:10 EDT 2004 | Grant
Hi, We have both Vapor Phase ASSCON semi auto as well as Soltec convection inline ovens. I must say we had no end of problems with Vapor Phase. We tried everything, and just could not totally eliminate tomb-stoning completely. We would always get a
Electronics Forum | Tue Feb 24 16:44:55 EST 2009 | ldavis
Yes, we are only running no-clean pastes.
Electronics Forum | Mon Feb 23 14:44:08 EST 2009 | sunny
Are boards produced using Vapor phase ovens dirtier than N2 Reflow oven. Are there any studies/papers someone can point to? if not what are the methods to verify this? is IPC specified SIR test using 24B SIR test coupons? please advise. thanks in adv
Electronics Forum | Tue Aug 18 10:11:04 EDT 2009 | grantp
Hi, Yes, I think this sounds like a form of tomb-stoning, and we used vapor phase until it ended up driving us totally nuts trying to deal with tomb-stoning. We tried everything, and all kinds of stencil apertures. Vapor phase is an amazing process
Electronics Forum | Wed Jan 30 17:48:31 EST 2002 | davef
Expanding on a previous poster's comments ... Vapor Phase Soldering. A solder reflow technology that uses a heated solvent to melt the solder. Buried deep in the recesses of the SMTnet Library is �Terms & Definitions�. We started using vapor phas
Electronics Forum | Wed Jan 30 12:37:49 EST 2002 | jax
nifhail, In a nutshell: Vapor-phase reflow is a process that uses a fluid with a selected boiling point. As condensation of the hot vapor occurs on a cool assembly the assembly's temperature is rapidly raised to match the temperature of the vapor.
Electronics Forum | Mon Aug 16 11:36:23 EDT 2004 | soease
Hi everybody, now that lead-free is coming, I'm looking forward to change the oven we own in company I work for. Eternal question: what's the best oven technology on market. I allready know that we won't work with IR ovens, but I would like to have
Electronics Forum | Wed Aug 19 16:07:58 EDT 2009 | davef
We don't know dip about vapor phase soldering, but we can't help but wonder how well the leads of the component match with the pads on the board.
Electronics Forum | Thu Aug 20 19:07:29 EDT 2009 | smt_guy
reduce the stencil aperture to prevent tombstoning in vapor phase process. from my experience a 6 mil thick must be at least between 20 to 30 % aperture reduction for 0805's and below. cheers!