Electronics Forum | Thu Sep 20 09:12:28 EDT 2001 | jschake
If you were successful in running the machine in dry cycle mode, then I would expect with new squeegees that the prints would be acceptable. To give you more tangible data on what you may expect from the actual print results, maybe you could run the
Electronics Forum | Thu Feb 12 13:01:12 EST 2004 | patthemack
Thanks for your response. This is a DeHaart MPC-29. It has manual vision, no conveyor. When I bought it, only one camera was working. I fixed that, but while I was jacking with that, the electronic pressure regulator (spcjr) burned up without warning
Electronics Forum | Wed Sep 08 23:36:12 EDT 1999 | Jason Tomlinson
| | | Dear all, | | | | | | I don't know if I'm asking at the right place here, since you all seem to be more focused on process problems then programming problems (or perhaps programming isn't a problem for you). | | | | | | I'm using FUJI CP642's
Electronics Forum | Wed Sep 04 09:47:41 EDT 2019 | smrsteve
Hello All, I've just bought a Quad 4c pick & place machine. It's so close to actually building boards, but just doesn't quite get there. I was wondering if there's somebody out there with experience of these machines that might be able to help...?
Electronics Forum | Tue Sep 29 09:39:02 EDT 2015 | rgduval
Hey, David, For service, check out 4TechUSA over in Detroit. It's not Chicago, but, you're closer to Detroit up there than I am down here in Houston :) For your issue....do you have access to the UIC Knowledge Base? The first issue I found in the
Electronics Forum | Fri Feb 11 18:51:16 EST 2005 | primus
The operators use SET SEQ and SET SEG. I know all about getting these wrong, because if you forget the "Q" or the "G" you get SET SE which is SET SENSOR. That REALLY messes up our BEC! But then again, I believe our BECs are all calibrated wrong anywa
Electronics Forum | Mon Mar 05 18:56:47 EST 2001 | davef
Stefan: Thanks for the clarification on the Siemens machine operation. Yes Stefan, Germany and some other countries have wonderful apprentice programs. Generally, we Americans have the patience of a staving gerbil for such things. Is the ON butto
Electronics Forum | Fri Jan 22 15:48:14 EST 1999 | Chrys
| Hello, | | I will be evaluating and qualifying two equipment types. The first is a fountain soldering device. I need practical advice on all the stuff you guys and gals know about as good, bad, ugly, best applications, setup, limitations, and all
Career Center | Cavite, Philippines | Maintenance,Production,Technical Support
SKILLS: Mandarin, English skills Quick Learner, willing to be trained Knowledge in Automatic Insertion and Surface Mount Technology Machine (Industrial machines) Can handle and Troubleshoot Electromechanical machines Can read and
Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef
Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c