Electronics Forum | Wed Mar 25 19:41:01 EST 1998 | Earl Moon
| We have successfully put .016" vias in .030" pads. | There is no drain off with .030" solder balls, since | the actual volume in the .002" depression is low. | We did notice random bubbles where, apparently, the | solder reflowed and trapped the a
Electronics Forum | Wed Mar 25 16:36:10 EST 1998 | Steve Joy
We have successfully put .016" vias in .030" pads. There is no drain off with .030" solder balls, since the actual volume in the .002" depression is low. We did notice random bubbles where, apparently, the solder reflowed and trapped the air in the
Electronics Forum | Sat Jun 28 22:52:34 EDT 2003 | ramanandkini
We have an Electromechanical assembly (clock) that has a step motor on the board. This electromechanical assembly is assembled in a screw less plastic moulded casing. The plastic casing is neither air tight nor water proof. The board is with SMOBC+ H
Electronics Forum | Mon Sep 30 09:26:04 EDT 2002 | itempea
Russ, first step would be to get IPC-7095 on BGAs. A few notes: There can be voids in solder balls, or at the solder joints to the BGA, or at the solder joints to the PCB. Various sources or reasons can be responsible for these voids. Voids can be
Electronics Forum | Tue Feb 03 13:39:08 EST 2009 | grics
Good morning Jamie. I work at a CM and can offer some input on process flexability. I do not have any data on how reliable the coating is but I can say that they are both very difficult to control. Will you be selective coating or full coating? Ho
Electronics Forum | Thu Mar 30 21:46:56 EST 2000 | Dave F
Reg: This is copy / paste from draft version of IPC 7095 ( issued May 1999 ) ... 7.3 Assembly accept/reject criteria 7.3.1 Voids in solder joint a. Sources of Voids There can be voids in solder balls, or at the solder joints to the BGA, or at the so
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
.gif)
.png)
