Electronics Forum | Thu Aug 25 06:57:41 EDT 2011 | SBecmpe
I just started with this company and the machine is being used for a different process. I am noticing small differences in the wiring that do not appear to be original. Ex. The SMEMA is missing. There are unmarked wires. Schematics would really set m
Electronics Forum | Sat Dec 10 22:31:16 EST 2016 | ecogroup
Hi Tom, We have a Paragon 150 with the FCU board problem. We are thinking about finding another board and swapping it . Did you get the ROM chips from BTU when you swapped the FCU board? Appreciate any advice. Thank you. Ray
Electronics Forum | Wed Dec 14 13:44:14 EST 2022 | assuredtech
Do you have the electrical schematic? The matting connector should be right there at the machine frame just under the mounting hole for the light tower. Light Towers can be an "option" on machine configurations, perhaps your machine was not configure
Electronics Forum | Fri Oct 28 13:58:57 EDT 2016 | ttheis
Hi everyone, We just picked up an old VIP70 oven and it is in need of more maintenance than we were told when we bought it so I'm working on a few issues. The main thing right now is linking the FCU controller to the PC. I've tried using both seria
Electronics Forum | Tue Jun 20 08:40:40 EDT 2006 | dallen
This is a long shot, but can anybody advise on the supplies for a BTU oven. It is currently in the UK and is supplied by a 415V 4 wire. That is 3 phases and a neutral. We need to ship it to our plant in Mexico where they have a 480V 3 wire supply.
Electronics Forum | Mon Jun 26 04:41:06 EDT 2006 | dallen
Thanks for all the responses. BTU has now informed that the reason it is so expensive is the oven heaters need completely rewiring and some work in the transformer area etc is required. Also, we have to pay for engineering work for them to know wha
Electronics Forum | Mon Nov 06 11:26:09 EST 2006 | Rob
I''m sure I remember BTU telling me that the VIP series got the same contollers as the ancient TRS14's. Someone may want to verify this - but if correct you can pick up a TRS for beer money & rob the controller. A new 7 zone BTU Pyramax can be ha
Electronics Forum | Sun Nov 12 21:18:31 EST 2006 | fastek
Kris- You obviously need to become more self-sufficient if you are struggling to keep your reflow oven up and running. Reflow ovens are too simple to repair to get freaked out over them. It's not always the vendor's fault when the customer doesn
Electronics Forum | Mon Nov 13 04:30:16 EST 2006 | Loco
:o You wouldnt happen to have shares at BTU, Fastek? What you are replying is just what Kris was talking about. I wouldnt take it either. Customer service should be very important for any company. Imagine a broken oven, company coming to a stand
Electronics Forum | Wed Nov 18 13:00:16 EST 2009 | evertonsanches
Dear All, > > I have a problem with the > BTU-Paragon 150 10 Zone Reflow Oven. Am not able > to lift the HOOD using the buttons on the Main > control panel. I have checked the Lift hood > switch & Ok. Pls. advice / Suggest. > > Thx in > advanc
