Electronics Forum | Mon Oct 06 15:04:26 EDT 2008 | mikesewell
I've installed both (at different companies),currently a MPM 125 user. The DEK seemed slightly easier to program a new board. I guess it depends on which platform you're most familiar with. The Hawkeye inspection we had is fast to setup but doesn'
Electronics Forum | Sun Jul 14 16:46:38 EDT 2019 | rob1
I'm working on A DEK 265 Horizon and I need to convert it to right to left. I have changed the conveyor direction in software, however, the board stop position appears to be from 0 to 255 and I need it stop on the left hand side of the centre referen
Electronics Forum | Fri Feb 29 16:42:34 EST 2008 | vikkaraja
Hello again, Has anyone experience any problem with their vision system on the DEK machine. Machine had been running fine for at least one year without any major problem until this week. Machine's response is very slow especially the vision system. M
Electronics Forum | Mon Oct 05 17:07:31 EDT 2020 | dekhead
Older machine models (Horizon / Infinity) allowed you to offset the board stop (thru crative programming) to run the larger board with parameters for the smaller board. That feature is eliminated with the Micron series. However, if you can get remote
Electronics Forum | Tue Jun 03 20:09:31 EDT 2008 | fastek
Look in your manual. There are also calibration stencils and boards necessary to calibrate DEK printers. Do you have them? If not I might have a set I would sell.
Electronics Forum | Mon Jan 20 03:13:34 EST 2020 | silverlead
Included screenshots from DEK manual, outlining stencil depth adjustment. Basically, distance from rear of the stencil to the front of the image is value needed to be set on scale when positioning stencil. There is an other way to adjust stencil, by
Electronics Forum | Fri Oct 02 13:55:58 EDT 2020 | lesfarnacer
hi , need help please with my DEK Horizon 03i , we trying to programme a longboard 600mm on the printer and board lengh on our printer is limited to 510mm . I checked on the hardware eve thing is ok but in the software we don't have the longboard op
Electronics Forum | Wed Oct 24 16:54:54 EDT 2007 | dekhead
It's an Horizon (01) with large board (24" x 30")capability. Some software issues, as the OEM stopped progressing software on this machine (an offshoot of Horizon 7SP02) and never made final release Typhoon software compatible with this (Same with Vi
Electronics Forum | Mon Jan 30 06:29:44 EST 2006 | robls
We are a Contract Manufacturer in South Africa. We currently have a Speedprint SP200AVI fully automatic printer with 2D vision etc etc. We require a second fully automatic printer and are busy evaluating a DEK Horizon 03i. We have found good points
Electronics Forum | Mon May 05 15:52:22 EDT 2008 | dekhead
Assuming you have the scale that corresponds with Board Width for center justified stencil. Formula would be: 2 x (distance to image {mm} - 368) = Board Width (setting on scale) http://www.dekhead.com/
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723