Electronics Forum | Wed Sep 20 17:06:23 EDT 2000 | jackofalltrades
On the Vitronics/Soltec Wave Soldering Machines, we have no problems with the hot air knife (called a "Select X De-Bridging Tool" by Vitronics). We have both Delta's and Delta Max's. We have used both air and nitrogen with no problems. When using a "
Electronics Forum | Mon Apr 09 11:31:36 EDT 2018 | emeto
I would still focus on the sensors first. Experiment and see if they are really registering correctly. Still might be a sensor malfunction, timing issue(enough time to register)or some actual debree on it that prevents it from changing state properly
Electronics Forum | Mon Apr 09 13:50:38 EDT 2018 | justconmac
Thank you, yes I am definitely going to go back through and clean them thoroughly and monitor them, especially at rack location.
Electronics Forum | Thu Sep 02 10:41:41 EDT 2004 | dj_jago
Other way around Dave. We decided that the Delta had more in common with the Electra rather than the Vectra, the Electra being much more expensive. For example, we wanted 3 preheat zones for lead free and this would mean an exernal fluxer unit if
Electronics Forum | Tue Aug 24 05:02:55 EDT 2004 | dj_jago
Hiram, We have just had the same decision to make! I was at Vitronics Soltec, Holland about 4 weeks ago doing trials for Lead Free. The Soltec Delta machine was ultimatly chosen over price verses performance. Both machines are very capable but
Electronics Forum | Thu Jan 05 15:34:55 EST 2006 | Joe Wesley
Electrovert does not seem to be cheaper. Still about 30K more than the Delta. We are investigating too, we are concerned about the dross build up and flow design in the electrovert. The Soltec Machine seems to have less of an issue and maintenance ap
Electronics Forum | Mon Apr 09 14:51:04 EDT 2018 | justconmac
UPDATE The reason for the board count in the wave when there are no boards is due to operators leaving racks with empty PCB slots. The input feed sensor is a little bit more in the center of the conveyor whereas the output feed is a slightly closer t
Electronics Forum | Wed Jul 11 09:11:07 EDT 2012 | cbeneat
To check the airflow for your exhaust, use a manometer. Testo makes pretty good low cost models. Your machine manufacturer should be able to tell you what the requirement is or it's in the manual under setup. If it's a Vitronics Delta wave, I can
Electronics Forum | Fri Jan 13 22:57:19 EST 2006 | John
The New Redesigned Vectra , should fit right into the same price range as most mid-range wavesolder machines offer by most. We are looking to replace a existing Delta Wave and found the pricing about the same.But The upgrade prices can be high for no
Electronics Forum | Wed Apr 20 14:32:34 EDT 2011 | cbeneat
Hi all, A quick question to see if anyone can solve my issue. We are having problems with a particular board we run through our wave solder on a pallet. The board is populated with about 20 fuse clips, and one clip on almost every board gets fille