Electronics Forum | Mon Apr 09 14:51:04 EDT 2018 | justconmac
UPDATE The reason for the board count in the wave when there are no boards is due to operators leaving racks with empty PCB slots. The input feed sensor is a little bit more in the center of the conveyor whereas the output feed is a slightly closer t
Electronics Forum | Tue Aug 05 12:05:15 EDT 2003 | mleber
Through hole question - what methods can be used to obtain upflow on multi layer pwbs with huge ground planes. We are using a water soluble flux with a max temp of 220 topside. I am pushing the limits of the flux and hitting 250 topside in an attempt
Electronics Forum | Fri Jun 05 16:06:51 EDT 2009 | mjz289
This is from a section of an ALtera EP2SGX130-5 STRATIX 2 leadfree 1,508 ball BGA. What can be causing this? It is from an unused board (not assembled in a unit, or in the field, but it did pass electrical and function test. There are three of them i
Electronics Forum | Fri May 24 09:19:02 EDT 2019 | davef
http://www.nordsonselect.com. Accel: Cookson created Speedline after purchasing: MPM®, Electrovert®, Accel®, and Camalot®. In 2003, KPS Special Situations Fund II purchased Speedline from Cookson. In, 2007, Illinois Tool Works ITW acquired Speedlin
Electronics Forum | Fri Jan 13 22:57:19 EST 2006 | John
The New Redesigned Vectra , should fit right into the same price range as most mid-range wavesolder machines offer by most. We are looking to replace a existing Delta Wave and found the pricing about the same.But The upgrade prices can be high for no
Electronics Forum | Wed Aug 18 00:41:15 EDT 2004 | Grant
Hi, We have the Soltec Delta C. It works well, and is very stable. I think the software is a bit simplistic, but it keeps the wave stable, so that's the main thing. It's the timer on the software that I find annoying. It has a warm up time, and yo
Electronics Forum | Thu Oct 22 01:43:43 EDT 1998 | Frank J. de Klein
| My company is looking for higher density for card layout. One suggestion has been locating active components packaged in SOT's and SOIC's on the B-side of the card. This in turn will require wave soldering of the above mentioned components. When I
.png)