Inline x-ray inspection system for combined 3D and transmission x-ray analysis of double-sided boards with high package density. Universal standard system based on the MatriX X2.5 AXI system motion concept with 360º angle shot coverage. A new 3D reco
Industry News | 2014-08-20 11:40:53.0
Indium Corporation's Sehar Samiappan, area technical manager for North Malaysia, the Philippines, and Vietnam, will present at the SMTA Penang Chapter's meeting on Aug. 21.
The X3 is an automatic X-Ray inspection system featuring combined Transmission and 3D Technology for sophisticated high-speed inspection in electronic production. The system is based on the motion concept of the MatriX X2.5 AXI system. A newly develo
Industry News | 2020-06-07 04:44:33.0
PDR X-ray Solutions is pleased to announce that its 2D and 2D+ X-ray systems have set a new industry standard for high-quality X-ray images at an affordable price. Choosing the correct system for your requirements such as X-ray for quality control or X-ray for process control is vital for the success of both X-ray circuit board inspection programs as well as X-ray semiconductor inspection programs.
Electronics Forum | Tue Nov 13 21:59:42 EST 2007 | davef
This processes has the potential to cause barrel cracking and pad lifting, because the heating is very hot [troop crank-up the volume on their iron when they see thick boards] for a relatively small area on one side of the board. What do we suggest
Electronics Forum | Tue Nov 20 12:48:40 EST 2001 | tony_sauve
We recently experienced a problem w/voids (up to 65%) in uBGA solder joints. The only joints that have the problem correlated to pads which had blind 0.006" via's in them. The via's only extend down 2 layers, of the 18. 21 BGA's on the PCB, only expe
Electronics Forum | Thu Nov 22 12:56:12 EST 2001 | tony_sauve
Thanks for the comments & suggestions. Here's some info garnered from a telecon w/the PCB Fab house: -the blind via's extend from layer 2-17...this was a revelation. The info from our customer was that the via's only extended down 2 layers. Did I men
Electronics Forum | Sat Nov 24 22:15:16 EST 2001 | Glenn Robertson
Tony, I'm not sure if even baking will stop the voids if you have gaps in the plating. It probably doesn't take much moisture or even trapped air. I'm not speaking from a lot of direct experience here, so please run the tests and let us know wh
Electronics Forum | Sun Aug 19 15:34:20 EDT 2007 | davef
What are you trying to do: * Improve hole fill? * Reduce PTH voiding? Hole fill: Search the fine SMTnet Archives for stuff like: http://www.smtnet.com/forums/Index.cfm?CFApp=1&Message_ID=36063 PTH voiding: Ideally, there are no voids. We're unawar
Electronics Forum | Fri Mar 02 08:52:20 EST 2001 | markkrmp
Are your voids looking like blow holes also? Is this only occurring on the solder joints of the Thru Hole components and Via's? Or does this happen on SMD pads? My experience is that we have seen this but only with some of our older PCB's which are