Electronics Forum | Fri Jan 15 13:35:03 EST 1999 | Terry Burnette
| I saw the problem of void in solder bump or in lead less component or some BGA. But I didn't have standard specification of that void is accept or reject? Do any body have the better idea or suggestion of the criteria ? | | Thank you, | Wirat
Electronics Forum | Mon Dec 22 16:02:22 EST 1997 | Justin Medernach
| what is your experience about the presence of the voids in the joints ? | Are they dangerous and when ? Vincenzo, Voids in solder joints can be caused by a number of factors. Let's begin with the flux vehicle in your soldering media. If the prope
Electronics Forum | Wed Feb 05 15:16:15 EST 2003 | davef
If the voiding is not related to entrapped air in your vias, consider trying a different paste.
Electronics Forum | Fri Aug 06 10:27:05 EDT 1999 | Kenneth Hedman
| | I saw the problem of void in solder bump or in lead less component or some BGA. But I didn't have standard specification of that void is accept or reject? Do any body have the better idea or suggestion of the criteria ? | | | | Thank you, |
Electronics Forum | Mon Feb 06 15:50:10 EST 2006 | ajaygarg1980
Hi, We are electrodepositing Au(0.25 to 0.5 microns) on Cu & using solder ball bonding process via laser.We are getting lots of voids within the solder (not kirkendall voids). Can anyone shed some light on this problem.We are not using any flux.Pre
Electronics Forum | Thu Feb 19 14:21:35 EST 1998 | Earl Moon
| what is your experience about the presence of the voids in the joints ? | Are they dangerous and when ? Correct from 2% to 20% voiding unacceptable.
Electronics Forum | Fri Jan 15 08:11:34 EST 1999 | Jim Nunns
Our spec on voids is 30% ball diameter in the center. On the component to ball and pad to ball interface, we use 25%. To determine this spec, we asked around. I don't know of any studies that have been done to verify if this is OK Regards Jim |
Electronics Forum | Wed Sep 30 11:57:19 EDT 1998 | Manish Ranjan
Hi Everybody Is anyone aware of the possible causes that may lead to voids in the solder bumps after assembly. We assembled some dice on thin substrates and after assembly, void formation in the solder bumps were observed. We have already trie
Electronics Forum | Wed Sep 30 11:56:46 EDT 1998 | Manish Ranjan
Hi Everybody Is anyone aware of the possible causes that may lead to voids in the solder bumps after assembly. We assembled some dice on thin substrates and after assembly, void formation in the solder bumps were observed. We have already trie
