Electronics Forum | Thu Feb 19 12:56:29 EST 1998 | Earl Moon
| I'd like someone gives me a tip for elemating of voids | in the mico BGA solder joint and the method of inspection | of them, very exactly. Voids in excess of 20% by each solder ball volume is cause for rejection. Causes are improperly managed proc
Electronics Forum | Sun Dec 28 05:31:59 EST 1997 | Bob Willis
We have a x ray inspection criteria video and poster set which may be of interest check out our home page www.bobwillis.co.uk | | I'd like someone gives me a tip for elemating of voids | | in the mico BGA solder joint and the method of inspection |
Electronics Forum | Thu Jun 28 17:05:46 EDT 2012 | davef
Here’s what we seem to know: * There’s a problem with voiding in the solder connections of SMT capacitors * A void is an open area caused by air or process fluid that is trapped within a solder connection * Voids are an allowable condition as long as
Electronics Forum | Mon Jun 12 10:34:06 EDT 2006 | cuculi54986@yahoo.com
My brother-in-law is a DDS and I trust him. We had some problems with solder voids in the past, and he was invaluable. He'd drill them out and fill them with SAC3240X+.
Electronics Forum | Wed Mar 04 13:06:45 EST 2015 | cyber_wolf
A full blown analysis could become very expensive. There are many test that can be performed. 3D acoustic microscopy, X-ray, Dye and pry,and I'm sure the list goes on. Typically, a micro-cross section report of the BGA solder joints will show you w
Electronics Forum | Tue Nov 28 15:10:50 EST 2006 | M. Sanders
Unfortunately, I don't have a copy of IPC-A-610 D on hand, however, I believe in IPC-610, this �floating height� between lead and pad has no maximum specification restriction. As long as there is no voiding, it is still acceptable for all 3 classes.
