Parts & Supplies | SMT Equipment
Mounting bracket/ fixed block(P4410) Name: P4410; CA-773 MPM photoelectric sensor circuit breakers mounting bracket; fixed block Part Number: P4410; CA-773 Photosensor board stop bracket Description: P4410; CA-773 MPM photoelectric sensor circuit
Parts & Supplies | Other Equipment
Name: P4410; CA-773 MPM photoelectric sensor circuit breakers mounting bracket; fixed block Part Number: P4410; CA-773 Photosensor board stop bracket Description: P4410; CA-773 MPM photoelectric sensor circuit breakers mounting bracket; fixed blo
Parts & Supplies | SMT Equipment
Name: P4410; CA-773 MPM photoelectric sensor circuit breakers mounting bracket; fixed block Part Number: P4410; CA-773 Photosensor board stop bracket Description: P4410; CA-773 MPM photoelectric sensor circuit breakers mounting bracket; fixed
Used SMT Equipment | Screen Printers
MPM UP-2000 HiE inline printer available for sale with: Automatic board to stencil alignment Easy to use GUI software with on-screen operation instructions Flatscreen monitor and MPM/Logitech trackball Included option: 2D post print inspection (i
Electronics Forum | Thu Aug 06 11:41:10 EDT 2009 | swag
Is the aperture pattern on your stencil centered in the Y?
Electronics Forum | Thu Aug 06 12:46:15 EDT 2009 | jorge_quijano
Yes, it is centered, in fact is the same product we run everyday, problem shows up after maintenance was performed.
Electronics Forum | Thu Aug 06 13:54:13 EDT 2009 | lockj69w
We have this problem typically after a PM is performed and it is usually due to too much grease on the linear guide.
Electronics Forum | Wed Aug 05 14:20:21 EDT 2009 | jorge_quijano
Hello there, I'm having some problems w/MPM up2000, Vision Y axis software limit error, when I tried to create a new program, appears the "Value out of range for VY BSS POS, spec 0.00 min -26.5, read 8.45" message. Any idea of how to correct this pro
Electronics Forum | Fri Feb 19 11:17:29 EST 2010 | kpm135
When I try to load a board in our MPM UP2000 HiE I get the following error "Z axis software limit". The Z axis will move up and down freely, I re-calibrated it and reprogrammed the board and the error continues. Has anyone else run into this issue an
Electronics Forum | Mon Feb 22 10:19:57 EST 2010 | swag
Check/reseat all connections on axis driver card and from driver card to step motor. On older MpM's it is common to get a bad connection on the connector for axis driver power and blow components on your driver board. Reseating these connectors mig
