Water-based, alkaline defluxing for semiconductor electronics HYDRON® SE 230A is a water-based, single-phase cleaning agent specifically developed for the use in dip tank processes. It removes flux residues from a wide range of semiconductor electro
is a water-based cleaning medium, designed to quickly remove fluxes, solder pastes from PC boards, stencils, screens and mis-prints in heated and unheated spray-in-air and ultrasonic cleaning systems. It is recommended for wave solder process and ros
Technical Library | 2009-07-09 17:23:07.0
Sometimes you just cannot clean with water. Good examples of this are: circuits with batteries attached, cleaning prior to encapsulation, ionic cleanliness testing, and non-sealed or other water sensitive parts. High impedance or high voltage circuits need to be cleaned of flux residues and other soils to maximize performance and reliability and, in these types of circuits; water can be just as detrimental as fluxes. When solvent cleaning is called for, Hansen solubility parameters can help target the best solvent or solvent blend to remove the residue of interest, and prevent degradation of the assembly being manufactured. In short, using this approach can time, manufacturing cost and reduce product liability.
Specialty Solder Products for SMT Assembly- Solder Paste (No-Clean, Water Wash), Solder Spheres, Fluxes, Preforms, Wire, Ribbon.
is a water-based cleaning medium, designed to quickly remove fluxes, solder pastes and SMT adhesives from PC boards, stencils, screens and mis-prints in heated and unheated spray-in-air and ultrasonic cleaning systems.
1.Modularized heating system. 2.Nitrogen protection system. 3.External high-power water-cooling system. 4.Flux Collecting system.
Used SMT Equipment | Soldering - Reflow
BTU Pyramax 125N Parameters Pyramax Specifications Model Pyramax 125N Atmosphere Air or Nitrogen Conveyor Speed 10-60 in/min 25-152 cm/min Conveyor Width 2-18 in 51-457 mm Heated Length 125 in 3175 mm Heated Zones&
New Equipment | Cleaning Agents
Broad Spectrum Electronics Cleaning Solvent IONOX® I3302 is a semi-aqueous solvent blend designed to remove difficult flux and paste residues including lead-free, rosin, no-clean, and tacky flux, as well as other common electronic assembly residues.
New Equipment | Wave Soldering
Maximizes Yields and Reduces Rework The ECD Fluxometer® maximizes yields and reduces rework by qualifying your spray fluxer pattern uniformity and top-side-penetration. Improve Process Quality - Eliminate guesswork when it comes to managing the c
Used SMT Equipment | Soldering - Reflow
Low Hour Heller 1707MK5 Ultra Low Nitrogen & Power Consuption Reflow Oven Available (7) Top/Bottom Lead Free Heat Zones Edge Rail With Auto Lubrication & Mesh Conveyor (Left to Right Travel) 45MM Clearance Above & Below Edge Rail Conveyor Pins Inert
.jpg)
