Industry News | 2013-03-21 09:14:58.0
EVS International, will debut the newest system in its award-winning EVS series, the new EVS 8K LFHS Lead-Free Solder Recovery System, in distributor SMA Technologies’ Booth # L70 at the upcoming 27th International Electrical, Energy and Automation Industry Fair (FIEE), scheduled to take place April 1-5, 2013, at the Anhembi Exhibition Centre, in Sao Paulo, Brazil.
Industry News | 2009-01-30 16:42:42.0
San Diego � January 2009 � KIC, the leader of thermal process development and control products, and winner of multiple industry awards, announces that it will feature KIC's new RPI, Reflow Process Inspection. KIC also will be showing the KIC Explorer Dual model that may be used as a datalogger or as a real-time profiler using radio frequency technology. KIC will be in representative Mectronics Marketing Services' booth, located in Hall #18 in booth #406, at the Componex/Nepcon India 2009, scheduled to take place February 24-26, 2009 in New Delhi.
Industry News | 2009-03-27 10:06:36.0
San Diego � March 2009 � KIC, the leader of thermal process development and control products, and winner of multiple industry awards, announces that it will feature KIC's new RPI, Reflow Process Inspection.
Electronics Forum | Mon Jun 12 10:57:51 EDT 2000 | Jason
I am new to wave soldering. Any information is greatly welcomed. Here is the problem. After soldering the boards they have a film on the bottom of them and sometimes a white powder looking substance. I have tried decreasing the amount of flux on
Electronics Forum | Mon May 07 12:04:59 EDT 2007 | patrickbruneel
Jerry, If you�re sure your board has sufficient flux it must be that your slow flowing (single lambda) wave produces more oxides then the flux can handle. Due to the conveyer angle the front of the board usually has less flux then the back of the bo
Electronics Forum | Mon May 07 11:09:49 EDT 2007 | davef
4 Fluxer Operation 4.1 Set-Up and Check-Out the Fluxer 4.1.1 Spray Fluxer Set-Up and Check-Out 4.1.1.1 Pass a sample unsoldered board through the machine. 4.1.1.2 Remove the board just after passing through the fluxer and the air knife. 4.1.1.3
Electronics Forum | Fri Dec 01 08:09:08 EST 2006 | CK the Flip
Square-leaded pin headers will typically bridge at the trailing edge (last couple of leads), since during peel-back, the solder at the trailing edge has "nowhere to go". If you have control over designs, ask your designers if they can put solder thi
Electronics Forum | Mon May 19 10:35:58 EDT 2008 | samir
I agree with RealChunks. The application of any of these "wave solder process control tools" is dependant on how the shop is run. At some shops, PM is inconsistent and slacked off on. At other shops, there is no technical expertise at the operator
Electronics Forum | Mon Jan 31 12:24:24 EST 2000 | Dave F
Robert: Several points: 1 Dross is a mixture of various things with no "fixed" composition: � The obvious things are metal oxides mixed with metal and this can vary in color with temperature and composition - remember some intermetallic oxides form
Electronics Forum | Thu Nov 08 16:02:28 EST 2007 | ck_the_flip
We've got lots of connectors at my place of employment like this. What I do is... I run these "slower than molasses in January" - we're talkin' 2 Ft/Min. conveyor speeds. Obviously this will have an effect on your thermal profile so compensate acco
.gif)
winsouce.jpg)